I need some help, what are you actually trying to do and what are you referring to as the flange?
tap outward on flange area to "pop" it out off the C-clip retainer/ install same way.
4 flange bolts behind hub and you will need a slide hammer to remove the axle!
The standard rear axle width, on your 1995 Chevrolet Z 28, is four inches. Some limited models were equipped with a five inch axle width.
Loosen and remove center hub bolts Slide axle out Remove spanner nut Remove drum
purchase vw tool for removing special bolts the hold inner joint to flange, jack up car, remove wheel, unbolt lower ball joint, remove tie rod nut, separate tie rod from steering knuckle, remove axle nut, pry lower control arm down and pry steering knuckle away from car, unbolt inner joint from flange and remove axle, be careful not to damage abs sensor wire,
How to remove the right side axle half on a 1995 f150
First, remove the axle. Then, user a large screwdriver or a seal remover to remove the seal. Tap a new seal into place with a hammer. Reinstall the axle and fill the differential lubricant.
remove the axle nut on the side with the brake hub...and pull threw the other side....very simple
Your best bet is to have someone do it for you. But if you insist then I insist that you buy a Haynes manual.
Remove the tire and wheel from your 2003 Chevrolet. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing in the wheel seal. Reverse the process to install the new wheel bearing.
The Chevrolet suburban 1500 axle is interchangeable with the Chevrolet Silverado 1500 axle. The manufacture year of the vehicles should be the same.
Jack and secure vehicle. Remove tie rod nut and separate of knuckle. Remove axle nut and strut bolts. Use pry bar to remove inner CV joint from trans. Pull CV axle from vehicle.