The way I did it was by removing the 2 screws on either side of the light. Pushing up the light and turning it so as I could pull it out. Once it was out I replaced the bulb and put it back in the slot in reverse order.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
To fix a license plate light on a 1995 Dodge Colt you must first remove the screws holding the light cover in place. Remove the light from the bumper completely. Remove the license plate light bulb from its socket and replace with a new bulb. Place the light assembly back in its place in the bumper. Secure the light assembly in place with the screws you removed.
hello i need you help me tell me how to remove the cover light from a license plate i have a ford focus se 2002 to put a new light thanks willie
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
Open your trunk and find the wires that go to the bulb over the license plate. Twist the base to remove the light.
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
IZ 3820
To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.
Open trunk, plate fits through a slot--just push up from the outside front of plate
Because this bulb is mounted vertically, it can be tricky. The recommended method is to remove the license plate and open the trunk lid.
Rear license plate lights replacement require that you remove the entire frame with reverse lights. Remove the 3 cover bolts on the inside of trunk, remove license plate, remove the for bolts holding frame to tyrunk lid, slide unit down and out and you will have to twist the bulb sockets and remove the bulbs and install in reverse.
To change the license plate light on a 2002 Geo Tracker, remove the light lens with a small screwdriver. Take out the old bulb and replace with a new one. Tighten the screws on the light lens.