How do you remove the rear brake drum from Kawasaki Bayou 220?

Answer 1

How to remove.

1988-1995 Kawasaki Klf Bayou 220 rear brake drum.

1. Remove the rear wheel

2. Pull the cover off the grove in the end of the brake drum.

3. Remove and discard the axle nut cotter pin.

4. Loosen and remove the axle nut and washer.

5. Slide the brake drum off the rear axle and remove it.

Note: The brake drum should slide off the rear axle with little or no effort. If the brake drum is tight, Loose the brake adjuster.

I hope this help's.

Answer 2

you will need to jack it up so the wheels are off the ground and hold it up with either a jack stand or a cinderblock, i did front so i put a cinderblock under where the front A-arms connect. First take off the wheel, it should have 4 nuts, remove all four. then you can see a pin will a ball on the headattached to the front of the axle, you will have to bend it so it is completely straight. tap the pin with a hammar on the bottom (Not the side with the small ball) slowly so you dont bend it but hard enough so it will come out. After getting off the wheels and getting off the pin you will see another nut on the axle. on mine that nut was extremely hard to remove so i PB blasted the crap otta of it and it came off after some serious pulling and pushing. after removing the wheel, the pin on the axle and that nut on the axle you will be able to slide off the drum and see the inside of it and see the pads. sorry for the spelling/hard to follow instructions, Im only 13.