tHAT IS WHERE i AM TODAY. iT WILL HAVE TO BE ANOTHER DAY WITH A LOT OF SUNSHINE HOURS. i WAS ABLE TO FIND THIS MUCH ABOUT SUZUKI'S. REMOVE THE PARKING CABLE CABLE AND LEVER TO GIVE YOU EXCESS CLEARANCE WHEN YOU REMVOE THE DRUM. YOU WILL NEED A SLIDE HAMMER AND ATTACH TO REAR DRUM AND REMOVE THE DRUM WITH THE SLIDEHAMMER. BE CAREFUL OF YOUR FINGERS YOU COULD ALSO USE A GEAR REMOVAL TOOL AND ATYTACH TO THE 2 SCREW HOLE (LOOKS LIKE 8MM) AND PRESS IT OUT.
i was wondering how to change rear brake drums for 1999 Chevy venture
first you have to take the wheels off of the van,and then you have to take the tension off of the brake shoes. Next you will be able to remove the rear brake drums off of the vehicle.You may have to tap them with a hammer to break them free.
Remove the wheel and tap the drums at back with a 'deadblow' hammer, rotating the drum as you do this. The brake shoes tend to hold drums on.
If you are inexperienced, you should not be messing around with the brake drums.
brake drums should pull off if not rusted on.
Remove the wheels, pry the drums off.
Remove the wheels from your 1995 Toyota Camry. Remove the brake pads by removing the brake pad Springs. Tap on the brake drum with a hammer or mallet. Slide the brake drums off. Reverse the process to install the new brake drums and shoes.
How do you change rear brake drum on a 2004 Chevy Venture?
Remove the drums and take them to an auto parts store that has a brake drum lathe.
Remove the tires and wheels. Remove the brake pads and hardware. The brake drums will slide off. Reverse the process to install the new brake drums.
experience and a big hammer
best answer is take it to a brake shop it's not something that should put your life on the line for. but if you have to do it you will need a Chevy brake tool or an Allen wrench to remove the calipers then its simple to switch out pads. drums again I recomend a shop.
Begin by removing the break assembly from your 1994 Mercury. Tap on the rear brake drums with a hammer or mallet. The brake drums will become loose and will simply slide off.
To change wheel cylinder on a 2000 Chevy Malibu, jack up the vehicle and remove the tires, brake drums and brake shoes. Spray the hydraulic line and fitting with CRC 5-56 and loosen hydraulic fitting. Remove the two mounting bolts and remove the wheel cylinder. Replace with new.
very carefully :)
do you have a video
Pads on front. Drums on the rear.
Remove the wheel and tire. Next, remove the axle end cap. Remove the brakes and all hardware. The brake drum will slide off.
On the drums there are two holes. You need to insert two to bolts (size 10 metric) in to the holes as yoo tighten the bolts it pushes the drum off. bolts need to be about 3 inches long. i could be wrong about the bolt size
No, the drums can be cleaned with brake cleaner.No, the drums can be cleaned with brake cleaner.
Remove bolts at center hub Slide axle out Remove spanner nut drums should slide off
Brake drums are not attached with fasteners, they just pull off once wheel is out of the way.
remove rear brake drums
It sounds like your brakes are grabbing, which is often caused by oil, grease or brake fluid on the brake shoes or drums. Take the brake drum off and if you find any contamination on the lining or the drum use brake cleaner to remove it.
Jack up, remove rear wheel, remove emergency brake cable, loosen bleeder valve and bleed as normal.