u need to remove small rubber dust cover from back side of brake backing plate. then with a sturdy but small screwdriver,thru this hole, u need to locate auto adjuster plate inside drum, u push small driver against this so it is pushed off the adjuster cam, then with flat screwdriver, or adjusting tool, at same time as u are holding adjuster plate, back off adjuster wheel as far as it will go this is akward to do, but brakes need to be backed off to enable drums to be removed drums wear and develop a lip on edge u should then be able to slide drum off. if still hard tap with a hammer while pulling drum
Remove the drums and take them to an auto parts store that has a brake drum lathe.
Remove the tire and wheel from your 1999 Chevrolet Suburban. Remove the brake pads and break assembly. Tap on the rotor with a hammer or mallet. When the rotor is loose it will slide off.
i was wondering how to change rear brake drums for 1999 Chevy venture
looking for help on the brake light ground wire location for 1999 gmc suburban 4x4
Friction.
Remove wheels Remove drums (Make sure parking brake is released Loosen and remove brake lines Remove mounting bolts Slide wheel cylinder out (may have to separate brake shoes slightly) Re-install new cylinders and Bleed new cylinders
Replace brake light switch.
You have to loose nuts and lift your car up. Then remove a wheel. There are two ways to remove brake drums. First using a hammer. Knocking the drum with a hammer in the direction opposite from the car. And second more efficient is to find two screws which fit threades in removing drum holes (two holes in a drum with a thread in it).
I had a problem shifting my suburban out of park. It ended up being the brake switch, it tells the transmission that you are pushing down the brake.
Change the brake switch located where the brake pedal is, a little above. Done!
with a brick
what is the question about the back brakes?? they are usually drums