Want this question answered?
Begin by removing the middle of your 1992 Mitsubishi Montero steering will. Remove the wiring harness. Remove the steering wheel retaining bolts.
The 93 requires a steering wheel puller, possibly the 92 also.
I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck!
Remove two screws 10mm from back of steering wheel,take the air bag part off the steering wheel after removing the two screws,then there should be one big bolt that you haft to remove . The steering wheel will come right off..
i have just removed one on a 1992 318i, it may be the same. carefully pry out BMW badge from steering wheel (i used 2 small jewellers screwdrivers) this will reveal one bolt, remove this and wheel should slide off.
The 1992 Mazda Miata is equipped with a non-adjustable steering wheel.
front left side and also left of the steering wheel. remove coin compartment
Remove screw @ bottom of horn pad. (After disconnecting Neg. battery cable of course.) Disconnect horn wire from pad. Remove center nut. Use wheel puller and REMOVE.
6Jx14 More information can be found at http://www.cabby-info.com .
by the steering wheel
The complete instructions are in Haynes manual #38025 (1420). You actually have to remove the steering wheel first. Amazon should have this cheap.
On my '91, it went like this: Borrow a steering wheel puller. Remove the horn pad, (four screws on the backside of the steering wheel. Remove the wheel. The rest is a cake-walk and simply a matter of Removal and reinstallation. The ignition switch has a tab on the side opposite of the key that is prone to breaking. It's quite doable without spending a hundred dollars an hour if you have a decent socket set and a steering wheel puller in hand.