== == 2 long, thin slotted screw drivers will work to pry open the clip that holds the crank on. It's a pain in the you know what. special tool needed may have one at a parts store
I use a thin wire hanger. Stretch the hanger from the middle of the bottom, as far as you can, so it is longer top to bottom. Straighten the hook of the hanger until it is as straight as you can get it, it does not have to be perfect. Bend the end of the straightened hook with needle nose pliers about 1/4 inch to a 90 degree angle. Slide the little bend parallel with the door behind the crank, in front of the plastic piece. Turn the hanger to catch on the clip and pull down. It may take two or three tries but it is much easier than using screw drivers. Also, be prepared to look for the clip on the ground, after it flies out.
Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
The window crank is held on by a "U" shaped clip. There is a special tool made to remove the clip. If you don't have the tool it can usually be pried out with a screw driver and a hook. Use the screwdriver to push out one side of the clip then pull the clip out with the hook.
You have to remove the inside panel, where the window crank is, or would be.
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
There is a c-clipthat holds the crank in place,you just need to push it off and the crank comes off.
behind the window crank
You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
Most chevys have a horseshoe shaped clip on the window crank. There is a special tool to remove it , but I just push them off with a small screw driver, or hook the back with a dental tool
The answer depends on what engine you have.
Window cranks are easy to remove. Go to the local auto parts store, and ask for a window crank removal too. Slip it in behind the crank until it comes free.
To remove the window knob,you need to purchase a tool at any auto parts store, you would then slide the tool behind the window crank and simply push out the clip that holds the window lever in place.
You need to remove the window hand crank with a window hand crank removal tool.