There is a retaining ring behind the window crank. The easiest way to remove and install this is to buy the tool to remove the ring. You can use two small flat screwdrivers to push the flat ends of the ring down at the same time. Then you can just pull the handel off.
Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
you can buy a window crank removal tool at an autoparts store that pulls the little pin off to remove it.
There is a small 'c' clip on the underside of the crank. A set of needle nose pliers are handy
If it's a true z34 90-94 there is no window crank they ALL had power windows.....
you need a special tool to release a clip behind the handle any body shop guy could help ya out.
there is a clip on the handle you have have the knob faceing upward and use a flashlight and a butter knife to remove. The clip is u shaped.
That year did not USE a Crank sensor.
You need to remove the window hand crank with a window hand crank removal tool.
How to Remove or Install Car Window Crank Handles check related link below
To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.
Pull out the U-clip located on the base of the window crank.