The problem may be in the switch, to test the accelerate portion you need a multi meter. Remove the steering column cover to gain access to the wire connector for the multi switch. Test for continuity between the top left connector pin ( flat side of connector is down ) and the bottom right when the switch is activated in accelerate. If there is continuity the the switch is good and the problem is in the ASCD control module. If no continuity is detected then replace the multi switch.
Make sure you have the main cruise control button depressed. You will then see a display light indiciating "Cruise Control". After that, just use the normal buttons to set, accelerate, and coast. BEWARE, though. The cruise control button for our 2004 Accord stopped letting me keep it in the depressed position, and I can't keep my cruise control on now. Will let you know once the mechanic takes a look at it.
No , absolutely not ( if you hit a puddle , which will slow the car down , the cruise control willtry to accelerate the car to maintain the set speed )It's not recommended to use the cruise control in the rain. Normally, you use the cruise control on the highways. When it's raining you need complete control on the car and be fully alert.( NO ) if you hit a puddle that slows the car down then the cruise control will accelerate the carbetter not it could cause the car to accelerate at the wrong time and cause loss of control
Check in your vehicle's owner's manual for reccomendation's regarding the cruise control. I have seen manual's that say not to accelerate up hill's with the cruise control.
Traction Control System
You need to check cruise control fuse and relay.
Have you tried pressing the cruise control button on the dash?
To the left of the steering wheel, below the dashboard is a button that says cruise control. Push that button in, the dash will illuminate the cruise control light. Then, as you reach the speed you want to cruise at, push the button on the steering wheel that says "set". When you want to turn cruise control off, simply tap the brake pedal and the cruise will go off.
To use the cruise control on the PT Cruiser, turn the cruise control on in the steering wheel. Accelerate to the desired speed and push in the end of the left turn signal knob. The cruise control should then control the speed. To take the car out of cruise control, a person can tap the brake.
Maybe the cruise control is set to the on position unknowingly.
cruise
answer: cruise control 86 Chevy capriceI think it is the button on the end of the wiper control.
push the cruise button on then the set button on some cars you cant set until you reach 55mph