0
> According to Haynes (38035), the Camshaft Position Sensor (CMP) is located on the timing chain cover. To replace - remove drive belt, the electrical connector and unscrew the mounting bolt from the CMP to the engine. Install a new O-ring on the new sensor and tighten the mounting bolt. Re-attach the electrical connector. For 3.4 L engines, the reference suggests removing the power steering pump (leave hoses attached) and setting aside to access the CMP. PB
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where is the camshaft sensor on a 1995 Chevy Monte Carlo?
i do believe that the camshaft sensor on the 3100 v6 motor is on the passeger side of the motor underneath the intake manifold and under the powersteering pump. i needed to replace the one on my 1996 lumina with that same motor and that's where i fould it. hope this helps.
95 crown vic Where is the camshaft position sensor?
The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.
Where is camshaft sensor on 1995 Nissan altima?
The Camshaft sensor is located under the cap and rotor of the distributor. This is a common failure on the 2.4L engine due to oil leakage into the distributor. how is the camshaft sensor replaced on 1995 Nissan altima. what other considerations are there.
How do you replace a camshaft sensor on a 1995 Chrysler LHS?
if it is a 3.5 like mine it is located right next to the thermostat and a 10mm wrench and 5 minutes
How do you change the winshield wipers on a 1995 Chevy lumina van?
replace a windshield wiper switch on a 1995 chevy lumina van
Where is camshaft position sensor located on 1995 chev truck?
There is no cam sensor on the 1995 year engine. GM. did not use a cam sensor on that year.
How do you replace the camshaft sensor on your 1995 ford F-250 7.3 liter diesel?
the camshaft sensor is located above the harmonic balcance on the front of the engine block it is easiest to access this from under neath the car to replace , remove wire harness from sensor remove bolt that holds sensor in block remove sensor.this will pop out of block,may need a small screw driverto get it started replace with new sensor, the attaching bracket will only go on , one way replace bolt reattach wire plug you have now replaced cam sensor
Where is the camshaft sensor located on 1995 eclipse?
The camshaft sensor is the same as the crankshaft sensor it is local on the passenger side of the valve cover . And going down to your crankshaft inside the timing belt cover
Where is the camshaft sensor on a 1995 Plymouth Grand Voyager 3.0?
It is inside the distibutor.
Where is the camshaft position sensor located on a 1995 Mitsubishi Galant?
Inside the distributor
Where is the camshaft position sensor located on a 1995 Chevy Tahoe?
That year did not have 1
Where is the camshaft positioning sensor on a 1995 jeep cherokee located?
Inside the distributor.
