0
How do you replace a rear seatbelt on a 91 PA if you have to remove the back seat how is that done?
Wiki User
∙ 18y ago
Grasp rear SEAT CUSHION, force toward rear of vehicle then pull up. Do both right and left sides of seat. Seat belt anchor volts will be visable. SEAT BACK unbolts at the bottom.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How you replace odometer bulb on a 98 Sunfire?
You have to remove the dashboard, then remove the instrument cluster. On the back of the cluster, you'll find that you can unscrew the bulbs from the back and replace them. I've done it myself on my own 99 Sunfire --- CanadianCynosure
How do you remove and replace levers on a dirt bike?
Remove the bolt in the lever perch. For a clutch lever, loosen the cable enough to remove the broken lever and replace the new one. Adjust the clutch cable back and replace the bolt in perch. For the brake (disc brake)) lever, you simply remove the bolt and replace lever, put the bolt back in the perch and you're done. If you have drum brakes, it is the same as the clutch lever routine.
How do you replace speakers in a 1999 Chevy pick-up?
Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.
How do you change rear parking lamps 93 thunderbird?
I am thinking you are talking about the rear corner lights pull back the carpet to see the light socket twist remove from the housing remove the metal clip keep clip put new light in replace clip put back in housing and twist replace carpet and shut trunk you are done
How do you replace the wheel cylinders on a Chevy Lumina?
remove the rear brakes, then remove the brake line to cylinder. remove the bolt holding cylinder on. then pull out wheel cylinder. to install cylinder, position it in place, put bolt back in cylinder to hold it. hook back up the brake line then put the brake shoes back on. when done bleed the system if need be.
How do you replace a heater blower in a 1999 Mercury Villager?
never done it on this model before but the one's I have replaced, I had to remove the glovebox and the blower motor is usually behind it. should be a couple of bolts holding it in. remove them, replace motor, replace bolts, viola, you're done. on a 97 its up under the dash didnt have to remove the glove box
Why is a vitrectomy done?
It may be necessary to remove the vitreous in order to replace the retina and restore vision.
When should one fasten your seatbelt?
One should fasten their seatbelt whenever they enter a vehicle or similar structure that they intend to travel in. This should also be done for short trips- a seatbelt can save a life at unexpected time.
How do you replace the headlight bulb located on a 2002 Jaguar X-Type 30?
Best done cold. from under the hood, there are to metal clamps on the back of the headlamp assembly and remove the cover then replave the bulb, on the driver side you can remove the battery for ease
How do you replace the headlight bulb located on a 2002 Jaguar X Type 30?
Best done cold. from under the hood, there are to metal clamps on the back of the headlamp assembly and remove the cover then replave the bulb, on the driver side you can remove the battery for ease
How do you install a seatbelt?
You simply scrunch it up and watch it suffer! Job done!
How do you replace rear wiper blade on 2007 Nissan Murano?
Buy the holder and blade $24 at a Nissan Dealer. Remove the plastic cap at the base of the washer arm it just pops off. Remove the 8mm nut and pull the whole assembly off, replace the blade holder and reattach the arm back and tighten 8mm nut. Replace plastic cap and you're done.
