Thermostat Removal & Installation 1. Disconnect the negative battery cable. 2. Drain and recycle the engine coolant. 3. Remove the Power Steering reservoir support bracket. 4. Remove the upper radiator hose at the thermostat housing. 5. Remove 2 thermostat housing retaining bolts and remove the housing. 6. Remove the thermostat and O-ring from the lower intake manifold. Discard the O-ring. To Install: 7. Clean the O-ring sealing surfaces. 8. Install a new O-ring, on the thermostat and position the thermostat in the lower intake manifold. 9. Place the thermostat housing on the lower intake manifold and install 2 retaining bolts. Tighten the bolts to 15-22 ft. lbs. (20-30 Nm). 10. Install the power steering reservoir support bracket. 11. Fill the engine cooling system. 12. Connect the negative battery cable. 13. Start the engine and allow it to reach normal operating temperature while checking for coolant leaks. 14. Road test the vehicle and check for proper engine operation. 15. Check the coolant level and add if necessary.
98 expedition
Go to this website. It will show how to remove the door panel and the side mirror.
all the door speakers are 6x8 on the 98 ford expedition.
I paid $89 for a thermostat and $98 for labor
what causes the battery light to on a 2005 ford expedition to come on?
On a 1998 Ford Expedition : There are ( 5 lugs for each wheel , total of 20 )
Yes
Where is the ECM located on ford expidition 4.6
where is speed sensor location 98 ford expedition 4.6 engine nocruise control
replace it
$70.00 !
removed thermostat on 98 Bonneville and also removed rubber seal -- cannot get the old seal back into the housing.... help