answersLogoWhite
2000-2005 Dodge & Plymouth Neons
1995-1999 Dodge & Plymouth Neons
Dodge and Plymouth Neon
Ford Explorer Sport

How do you replace front wheel bearing of a 2000 dodge neon?

262728

Top Answer
User Avatar
Wiki User
2009-01-25 07:24:10
2009-01-25 07:24:10

ok first take of the rim...then remove brake caliper[2 screw in the back] then make sure that doesent hang keep it supported.... remove the brake rotor...disconect the ball joint...remove the steering knuckle from the suspension[2 bolts at the top...one on the bottom] remove the entire steering knuckle...get a bearing puller and pull the bearing out...replace and do it all over in reverse...

But what they don't tell you is that you need a hydrolic press to get the hub assembly and old bearings out and the new bearings back in which ends up being $70 or $80 for a shop to do... my suggestion is go to a junk yard and pull a knuckle with bearing already on it that don't move. easy fix, low cost...

123

Related Questions

User Avatar

how do i find out if i have ABS on my front wheel bearing , on my 2000 dodge Dakota quad cab 2 wheel drive

User Avatar

how to replace front wheel bearing on 1996 Hyundai elentra

User Avatar

Begin by removing the tire and wheel from your 1999 Dodge Adventure. Remove the end of the axle. Remove the wheel bearing retaining nut. Remove the wheel bearing seal and remove the wheel bearing. Reverse the process to install your new wheel bearing.

User Avatar

You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.

User Avatar

The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.

User Avatar

To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.

User Avatar

The front spindle must be removed as the bearing is pressed in. Not a job for a beginner, but if you have some auto expertise, not too difficult...

User Avatar

Front is easy, just replace hub rear is pressed in

User Avatar

Is the wheel bearing on the front or the rear ????.. There is a big difference ...

User Avatar

The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.

User Avatar

you can replace it by taking it to the shop and they will do it for you.

User Avatar

How do you replace rear wheel hub and bearing.

User Avatar

Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.

User Avatar

How do you replace front wheel bearing on a ford focus

User Avatar

Remove the tire and wheel from your 2001 Chevy Impala. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.

User Avatar

Remove the tire and wheel from your 1992 Eagle. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearing.

User Avatar

You have to buy the wheel bearing assembly.

User Avatar

to change a front wheel bearing remove macpherson strut and press out bearings with a press, replace with press.

User Avatar

how do i replace front wheel bearings on golf 1.6 2002 model

User Avatar

it depends it it's the front or rear


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.