Fuel Pumps
Chevy Blazer
Chevy S-10
Chevy Blazer S-10

How do you replace the fuel pump located on a 1997 Chevy Blazer?

91011

Top Answer
User Avatar
Wiki User
Answered
2011-09-12 20:57:51
2011-09-12 20:57:51

first you must remove the fuel tank, disconnect the fuel pump and fuel level sending unit wiren and the ground strap, all hoses and fuel lines. lower the tank and remove from under blazer. be sure to clean off top of tank... there is a lock ring on top of tank at the fuel line connections gently tap the camlock counter clockwise (with a piece of wood or brass punch to prevent any sparks) tap tabs until they line up with the recesses of tank, then gently lift fuel pump/fuel sending unit out of tank being careful not to damage the fuel level sending unit... to install reverse of this

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how to replace a heater core in a 1997 Chevy blazer

I have a 1997 Chevy Blazer 4DR and the relay is located underneath the glove box.

How fast are you going? Fast speed = more gas burned per mile. Slower speed = less gas burned per mile.

this is incorrect. The fuel pump is located in the fuel tank. It is a lot of work to replace. I have done it twice on my 97 blazer. Its expensive too around 300 bucks. The fuel pump on a 1997 Chevey blazer is right beside the engine

The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.

The 1997 Chevrolet blazer actuator switch is located on the firewall in the engine compartment. The switch is on the passenger side of the engine compartment.

The oil pressure switch on a 1997 Chevy Blazer is located on the bottom of the engine, near the oil filter. It monitors the output and pressure of the oil pump.

Will a 1997 blazer what work on a 1999 blazer????? If your talking engine, transmission, or running gear than yes. It is all the same.

The 4.3 liter V6 engine in a 1997 Chevy Blazer has a timing CHAIN

The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.

Ignition control module.. located under the distributor The distributor cap is probably cracked and moisture is getting into it. Replace the cap .

Behind the dash assembly, big job for the faint at heart.

Should be on top of the starter - follow the + battery cable

The ground strap on a 1997 Chevy Blazer 4.3 Vortec is located along the bottom of the engine near the frame. It ensures that electricity flows properly through the entire vehicle.

I'm trying to figure that out to but so far it seems to involve pulling the rear axle

buying a chilton or haynes repair manuel for the s series blazer will help in knowing how to change it

a 4 door 97 blazer front how do i do it

The 1997 Chevrolet Blazer didn't come with a cabin filter.

Freon is R12. Your 1997 Chevy uses R134 Refrigerant.

If the turn signal bulbs light but will not flash, the flasher relay is defective, replace it.

Assuming this is a 4.3L engine, it is located under the hood, in back of the engine, on top, close to the distributor.

it's located under the dash mid way left of the ash tray area

i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.

how to install time chain cover on a1997 blazer

You can replace Chevy Blazer 1997 and similar models with BMW's 7 series rims, and vis versa. I had 740IL rims from my cousins car on my Chevy 1997 Blazer 4x4 for 3 years and they worked great. I can only assume the brake parts on the GM cars are German made components, and this was why. No need to modify anything. They go right on and are a perfecr fit.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.