0
You should be able to find a shop manual at your local library with the right info...make copies as they are usually only in the REFERENCE section....good luck:)
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace a belt tension pulley of a 2002 Acura RSX?
push the tensioner back with a 14mm, take off the belt, take off the pulley assembly
How do you adjust the tension pulley on a 2002 Oldsmobile alero?
it is self adjusting .
What tool do you use to loosen the serpentine belt tension pulley on 2002 jeep wrangler v6?
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
How do you tighten tension pulley for 2002 Pontiac grand am 2.2L 4cy?
put your pp in the pistons
Tools Needed to replace front brakes 2002 Ford Focus?
Tools needed to replace front brakes 2002 Ford Focus?
How much should it cost to replace a vacuum tube on a Ford Focus 2002?
It will cost you about $743.00 to replace a vacuum tube on a Ford Focus 2002.
What kind of tool do you use to loosen tension pulley on a 2002 cavalier?
You would typically use a serpentine belt tool or a breaker bar with the appropriate socket to loosen the tension pulley on a 2002 Cavalier. These tools help you apply enough force to release tension on the pulley so you can easily remove or install the serpentine belt.
How do you release belt tension on a 2002 Dodge Ram?
usally' u put a 15mm or 5/8" wrench on the nut in the middle of the pulley & move the SPRING loaded Pully.IF U aren't sure wich Pulley-WATCH witch pulley Vibrates when the engine is idleing-then turn OFF the engine & replace the Belt.
Replace belts on 2002 Mitsubishi eclipse?
Put you car on jack stands, remove the right wheel. Loosen the tension pulley for the accessory belt (AC, alternator). Remove the belt. Loosen the tension pulley for the power steering, remove the belt. Install a new belt, and set proper tension. If you do not have a tool to measure tension, use rule of thumb. When the belt is under proper tension you should be able to twist only 3/4 of full twist. Do the same for the accessory belt.
How do you loosen the serpentine belt on a 2002 Kia Sedona?
You could do what I did, wait for the tension pulley to fall off the van...
How do you get 2002 Toyota rav 4 serpentine belt on?
Regardless of what type of vehicle you have, it is extremely difficult to replace a serpentine belt w/o a serpentine un-tension-er tool. This is a thin, long handle with a socket on the end that sticks out at 90 degrees of the handle. The socket slips onto the bolt-head of the tension-er pulley. Once the serpentine belt is threaded around all the other pulleys you put the un-tension-er tool on the tension-er pulley bolt and pull (or push) to achieve slack in the serpentine belt and slip it on the tension-er pulley.
How do you adjust the tension on a serpentine belt on a dodge Dakota 2002?
You don't. The serpentine belt tension is automatically maintained by the tensioner pulley, which is an idler pulley located on the passenger side of the system and looks like it doesn't drive anything. If the belt tension is incorrect, the tensioner pulley must be replaced. If the question meant 'how to release tension from the belt' (for removal, etc.), this is done by applying the correct size socket wrench to the tensioner pulley's center nut and rocking the pulley away from the belt.
