Best Answer

The water pump is driven by the timing belt on our '92 Dynasty 3.0 V-6, which I would assume is similar if not the same as a '93. You must remove a/c compressor, Power Steering pump, and front engine mount to access the timing belt and water pump. I would recommend a detailed repair manual to go by. It took me about 12 hours over two days to access and change the water pump and timing belt.

User Avatar

Wiki User

โˆ™ 2015-07-16 19:21:57
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the water pump on a 1993 Dodge Dynasty 3.0L?
Write your answer...

Related Questions

What does a 1996 dodge dynasty look like?

Dodge did not make a 1996 Dynasty. The last Dynasty was built in 1993.

Where is the blower motor in a 1993 dodge dynasty?

Underneith the Dash.

Where is a water pump on a Dodge Shadow 1993?

Yes there is. or would list how to replace

Will an automatic transmission from a 1991 Dodge Dynasty 3.3 interchange with a 1993 Dodge Caravan AWD 3.3?


How do you fix a wiper switch on a 1993 Dodge Dynasty?

change wiper switch

Which way is the thermostat placed in the housing of 1993 dodge dynasty?

Spring into the engine.

How much oil does a 1993 Dodge Dynasty engine hold?

4.5 quarts

Were do you locate the wiring harness from the fuel pump to the battery on a 1989 dodge dynasty?

The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.

Where is the sbec or ecm on 92 dodge dynasty?

On a 1993 Dynasty, it's on the engine compartment right front fender well.

Where is a picture of the top of engine for a 1993 dodge dynasty? this site is for mopar ( Chrysler , dodge etc.) excellent site

What transmission fluid type does a 1993 dodge dynasty use?

Mopar ATF+3

How do you replace a water pump on a 1993 Lexus Es300?

how do you replace a water pump on a 1993 lexus es300?

How do you replace a push rod in a 3.3l v6 engine on a 1993 Dodge Intrepid?


What is the Engine Oil Capacity on a 1993 Dodge Dynasty 3.0?

With filter the capacity is 4.6 quarts.

When you replace the timing belt on a 1993 Dodge Dynasty what is the firing order?

1993 Dynasty (irregardless of motor) will fire 1-2-3-4-5-6 with a counterclockwise distributor motion if it's the 3.0L. The cylinder block as you look at it from the front of the car is: _____________ | | | 1 3 5 | --------------- | 2 4 6 | |_____________|

How to change arack and pinion for 1996 dodge interped?

how to replace steering rack in 1993 dodge intireped

Will a 1992 dodge dynasty front fender fit on a 1993 dodge dynasty?

as long as the marker lights are the same ( some years don't have them ) i not sure which ones , Chrysler made all the dynasty bodies the same , you should be able to interchange most of them.

What is the size of the front and rear speakers of a 1993 Dodge Dynasty?

the front are 5.25 inches and the rears are 6x9s

How do you replace a serpentine belt on a 1993 Dodge Dynasty?

Where is the bcm in a 1993 dodge dynasty?

Body Control Module(BCM) is located inside kickboard(passenger side)

Where is the fuel pump inertia switch on a 1993 Dodge Dynasty?

Dodge doesn't use an inertia switch. It controls the fuel pump via a pcm actuated relay.

Where is the temperature fan switch located on a 1993 Dodge Dynasty?

The fan sending unit is on the side near the thermostat housing.

What is the best way to change the fuel pump on 1993 Dodge Dynasty?

Located in fuel tank - may have to remove for access

Where is the fuel filter located on a 1993 dodge dynasty?

Should be under the car just ahead of the passenger rear wheel

How do you reset the fuel pump on a 1993 dodge dynasty?

There is no fuel pump inertia reset switch on any Chrysler vehicles.