Have to remove the transmission.
You can't just replace the teeth, you have to replace the whole flywheel
how do u replace a flywheel in a Chevy zr2 s10 2003 v6
Remove the trany and you will see the flywheel bolted to the rear of the motor. Remove the bolts & replace the flywheel. Check the starter as a bad starter can chew the teeth off of a flywheel very quickly.
Remove the transmission unbolt the flywheel and replace.
No, there is no need to replace the flywheel but it is a good idea to have the flywheel surface machined.
If not replaced having it resurfaced is recommended.
NO.
You will have to remove the transmission 1st. After doing that then just unbolt the flywheel and replace it.
how hard is it to remove a flywheel on 2002 volvo s80
Have to remove the transmission.
Are we talking about excessive crankshaft endplay or a damaged flywheel? If its crankshaft endplay, replace the thrust bearings (and torque converter if automatic transmission). If it's the flywheel, replace the flywheel.
Take the engine shroud of the top of the flywheel - take the flywheel nut off - Put a puller on it and pull the flywheel off remove the old pieces of key and replace with a new one, and reverse process putting it all back together.