there are 2 ways, they changed methods around that year, turn the key on, engine off, and push the gas pedal to the floor 3 times within 5 seconds and the light should flash or beep when reset, or key on engine off, open the fuse panel door on the left side of the dash, press the red reset button once, the light will flash then hold it till the light goes out, if there is no red reset button in the fuse panel, its the first method, also consult your owners manual
Read you owner's manual.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
To reset the oil change light on a Pontiac Solstice, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within five seconds. After doing this, the oil change light should reset and turn off. If it doesn’t reset, repeat the process or consult the owner’s manual for further instructions.
To reset the change oil light on a 2006 Pontiac Montana, first turn the ignition key to the "On" position without starting the engine. Then, press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to verify that the oil change light has been reset. If the light remains on, repeat the process.
Hold the oil/trip Reset button while ignition is on (not car) for 8 seconds
To reset the change oil light on a Pontiac Solstice, first, turn the ignition key to the "ON" position without starting the engine. Then, press the accelerator pedal three times within five seconds. Finally, turn the ignition off and then back on to check if the light has reset. If it remains illuminated, repeat the process.
Reset the change oil light on Mazda 3
how do you reset change the oil light in a 2004 alero?
Your owners manual should tell you how to reset the light.
Turn the key on. Depress the gas pedal and release 3 times slowly. Should reset it.
http://www.gminsidenews.com/forums/f53/98-grand-prix-change-oil-light-stuck-59318/ For a 98 but same process.
turn the ignition to "Run" or where it would be once it was started, but dont start it. quickly push the gas pedal to the floor three times. the change oil light should start flashing and it will reset.