0
On the back side of the guage package. Remove the screw from KSW hole "A" and insert it into KSW hole "B". If the screw is already in hole"B" remove and move to hole "A". This will have to be done every 90,000 miles.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Check engine 2001 Isuzu Rodeo?
The check engine light for the 2001 Isuzu Rodeo often comes on because of a sensor that is damaged or malfunctioning. The most common sensor is an oxygen sensor and when reset, this often allows the light to be reset.
How do you reset ecu on 1999 Isuzu amigo 2.2 ltr?
unhook the battery for about 10 seconds...
How do you reset the timing belt light on Isuzu 2.8 turbo diesel?
how do you reset the digital miter timing belt light on Isuzu 2.8 turbo diesel
Can you reset the check engine light on an Isuzu amigo?
With most vehicles...you can touch the positive and negative battery cables together (disconnect from battery first) and it will reset the vehicle faults if they are corrected. Or go to just about any car parts store and they will do it for free.
How do you reset the oxygen sensor light on an Isuzu?
Never heard of nor have I seen an Oxygen Sensor light. If you are referring to the Check Engine Light, then that light comes on when there is a problem with the emissions controls. It may be a bad O2 Sensor or it may be many other things. Don't assume the O2 sensor is bad. Depending on the year vehicle you own, which you failed to mention, you reset the light on most 1995 & older vehicles by disconnecting the battery for 5 minutes. On most 1996 & newer vehicle, you reset the light with an OBD2 scan tool.
You have replaced the fuel pump in your 1998 Isuzu Amigo your fuel gauge does not read right how do you reset the ECU?
Did you disconnect the battery for a while?
How do you reset the Tire Pressure Sensor Default light on a 2009 Ford Focus?
hi how do i reset tire pressure sensor light on
How do you reset the oil light on a Chrysler PT Cruiser?
It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.
How do you reset a check engine light on a 1996 Isuzu Rodeo?
disconnect the battery
Where exactly is the O2 light reset switch on 94 Isuzu pick-up?
Or, if you're like me: 1.)buy a roll of the EXPENSIVE black electrical tape at Home Depot or Lowes. 2.)Carefully cut a square just big enough to cover the O2 indicator. 3.)Apply liberally. Good luck, and congrats to you if you have enough spare time to take the dashboard apart every 90k! 94 Isuzu Pickup O2 sensor light I followed the Amigo instructions below for turning off my pickup o2 sensor light and BINGO! It worked smoothly! It takes a little bit to get the dash apart. I had to reach behind the instrument console after I took the face off and pull the speedometer control cable off. Then it was as easy as below... 94 Isuzu Amigo, O2 Sensor Light Like most everyone else my O2 Sensor Light came on at 90K miles. I replaced it and the light would not go off. I disassembled the instrument cluster and looked for the "A" and "B" screws. In short my instrument cluster wasn't marked that way. I traced one side of the O2 lamp out and it went to a screw marked "KSW" there was also an empty screw hole marked as "KSW" almost directly opposite it with a dashed line imprinted in the circuit board between the two. I took the screw out of the 1st "KSW" and moved it to the 2nd "KSW", reassembled the gauge cluster, started the vehicle and the O2 light went out. Sure hope this helps out any 94 Isuzu Amigo owners with this repair. 89 Isuzu Pick-up, O2 Sensor Light Q: I have an
Will 02 sensor make engine light come on?
Yes, replace the sensor and have the dash light reset.
What is wrong when you rear abs and brake light sensor stays on in your 1995 rodeo?
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
