answersLogoWhite
Pontiac Grand Am
Ford Expedition Eddie Bauer
Ford Explorer Limited
Chevy Trailblazer

How do you reset the check oil light on a 1992 grand am?

222324

Top Answer
User Avatar
Wiki User
2005-11-18 18:55:35
2005-11-18 18:55:35

Turn key to on position with out starting. Pump gas petal to the floor 3 times. wait about 5-10 seconds and light should go off.

1

Related Questions

User Avatar

how to reset check engine light on 1992 Mazda mpv

User Avatar

You will need to go to a repair shop and have them scan for codes. That will tell them the problem and when it is repaired they can reset the light.

User Avatar

Try disconnecting the battery for 1 hour. This should reset the check engine light on this vehicle as it is OBD1.

User Avatar

== == how do you reset the oil light on a1992 corvette

User Avatar

After repairing the cause of the code, you can clear it with a scan tool.

User Avatar

Remove the positive battery terminal for 30 minutes. This will reset the light on this OBD1 vehicle. But remember that unless you repair the problem that set the light in the first place it will just come back on.

User Avatar

Disconnect the battery for 5 minutes get the radio code before doing this

User Avatar

The maintenance required light requires a scan tool to be reset.

User Avatar

It is possible to repair the 1992 deville check engine light if it is malfunctioning.

User Avatar

The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.

User Avatar

The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions. If the check engine light is flashing a misfire has been detected

User Avatar

Unhook the positive post to the battery for approx 10 minutes. That SHOULD take care of it IF the problem that triggered the light is fixed.

User Avatar

Auto Zone will check your computer codes for FREE... They will even check your charging system too...

User Avatar

Remove the battery cable for 5 minutes. It will come right back on, unless you repair the problem that tripped the light in the first place.

User Avatar

Check engine codes on Honda vehicles such as a 1992 Honda Civic have to be manually reset. To do so, remove the ECU fuse located inside the engine bay.

User Avatar

The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$

User Avatar

Disconnect the negative battery cable for 5 minutes. The light will go off but will just come back on if you do not repair the problem that caused it to come on in the first place.

User Avatar

In order to reset the radio in a 1992 BMW 525i, you will need a five digit code from the manufacturer. Once you receive the code, you can check your user manual for the correct sequence to reset the radio.

User Avatar

There is a small black slot on the left of the guage cluster. Put your car key in there, it should reset the light!

User Avatar

Simply unhooking the battery should reset the the PCM ( powertrain control module). If you have a check engine light on there is a problem that exists and that needs to be repair to reset any lamps that may be illuminated.

User Avatar

remove the ecu fuse for 30 seconds or the neg. battery strap for 30 sec or so. if you remove the battery strap all clock and radio presets will be lost.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.