push to inside door panel in alittle next to handle, look behind handle you will see a little metal clip. with a screwdriver push clip off, make sure not to loose the clip. pull handle off and reatatch clip to handle (makes reinstallation easier)
Your local auto parts store can sell you a tool for less than $10 that does the job.
I would also like an answer to this question. I purchased '
There is a spring clip located behind the handle that must be removed then the handle will slide off. You can purchase a tool for the job from most parts stores for very little money.
Don't know, would like to know.
There is a "C" clip behind the handle that must be removed. Your local auto parts store can sell you an inexpensive tool to help you remove the clip without damage done.
Your local auto parts store will sell you an inexpensive tool to do that job. There is a spring clip that has to be removed from behind the handle.
You need a special flat forked tool to remove window roller handle.
I'm assuming you are talking about the interior handle possibly the manual window handle. If so, you need to push on the area surrounding the handle to expose a small clip. use a standard screw driver to push the horsehoe looking clip to remove the manual window handle. To remove the arm rest there are two hex screws on either side..they are somewhat hard to find. You can then take steps to remove the inner door moulding.
There is a clip holding the handle. It is located in the center in the back of the handle. There is a tool to remove & install it; but you can use a flat screwdriver carefully. Good luck.
If it's the outer handle you would need to remove the door panel, then remove the rivits that hold the handle to the outside of the car. Then remove the window track and slide it down inside of the door and unhook the rod on the handle,and now you can slide the door handle out.
how do i remove an antenna to a 1998 chevy express 1500 van
how do I replace the inside door handle on a 1998 chevy cheyenne?
1. On manual window models remove the window crank handle dislodge the clip 2. Remove the outside mirror cover 3. Detach the door handle trim piece and disconnect the door pull mounting screw. Unplug the electrical connector from the power window switch 4. Remove the retaining screws and detach the panel by carefully prying it away from the door
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU