Q: How many torque pounds are required on a water pump for a 1999 Chevrolet Venture?

Write your answer...

100 ft/lbs.

454 engine torque is 752 pounds of torque

The 2003 Chevrolet Suburban front axle hub as a torque specification of 120 pounds. You should never exceed the torque specification as you will cause the wheel seal to fail.

The horsepower of a 1991 Chevrolet 454 cubic inch engine ranges between 240 horsepower and 350 horsepower the engine torque ranges between 700 pounds and 850 pounds.

The 2005 Chevrolet Malibu axle nut torque specification is 60 pounds. Over torque in the axle nut will cause the will bearing to fail.

Chevrolet Cavalier there are more than 100 torque specifications for your 2003 Chevrolet Cavalier. You can get a complete list of torque specifications from most Chevrolet dealerships.

anywhere from 85 pounds torque to 90 pounds torque will work, but factory is 87 pounds torque. personnally, i set mine at 100 pounds torque

Ratio of weight to leverage (or length) to produce torque or turning force, if it moves with a 1 foot lever when applying 1lb of weight then the torque required is 1 foot/pound or less.

Nothing over 35 ft./lbs.

The head bolt torque specifications for the 1986 Chevrolet Corvette is 200 pounds per square inch. The bolts should be torqued at 50 pound intervals.

The 350 cubic inch Chevrolet intake manifold bolts have a torque specification of Haiti pounds psi. The bolts should be torqued at 40 pound intervals.

46 foot pounds on short bolts 54 foot pounds on long bolts + 90 degees

739 ft lbs of torque

The Chevrolet 2.2 liter engine had bolt torque specification is 120 pounds. The head bolts should be torqued in 40 pound intervals.

92 foot pounds per lug nut. I found this answer in the owner's manual that came with the vehicle.

code p0305 is cylinder no. 5 misfire detected, and p0205 is injector circuit malfunction cylinder no. 5 good luck, I have a 99 Chevrolet venture also, they are riddled with problems.

90 inch - pounds (torque) = 90 / 12 = 7.5 foot pounds (torque)

The torque required to start a machine

200hp at 3200rpm 440ftpounds of torque at 1700rpm

Purchase a torque wrench with the correct range. If you need to do heads and high torque bolts get one which goes to 150 ft.lbs. If your torqueing lighter bolts oil pan, intake etc.. you can use a Inch pound range. Just multiply the torque required by 12. For example if the bolt requires 10 foot pounds the inch pound setting is 120 inch pounds. Buy a good wrench "click" type is preferred. Get your required torque numbers from the appropriate shop manual.

The Polaris Sportsmen 800 has 120 pounds of engine torque. The torque is measured at the flywheel. There is only 100 pounds of torque at the ground.

You need six pounds of pressure to torque.

The 1996 Chevrolet Cavalier 2.2 liter engine had bolt torque specifications are 120 pounds. The head bolts should be torqued at 40 pound intervals.

AnswerIf this is the V-6, then you must have a common problem...lower intake leaks coolant.The torque spec for the lower manifold is:First pass: 60 inch poundsSecond pass: 110 inch poundsLast (outer bolts only): 18 foot poundsUpper intake is a total 88 inch pounds in at least two steps.Randy

Load torque is the torque required by the load and motor torque is the torque available at the shaft of the motor.