0
How much oil is needed for a 1995 Cadillac Northstar 32 valve engine?
Wiki User
∙ 17y ago
REad your owner's manual/. 7 QUARTS TOTAL PAUL G it should be 7 and one half quarts to fill to the middle of the range.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How much oil is needed for a 1997 Cadillac Northstar 32 valve engine?
The oil capacity of the 4.6L 32 valve Northstar in a 1997 Cadillac is 7.5 quarts.
Does a 1988 Cadillac DeVille have a northstar engine?
No it does not. The only engine in the 1988 Cadillac De Ville was the 4.5 Digital fuel injected engine. The 4.5 engine is a 2 valve per cylinder overhead valve (not overhead cam) engine. It was a good engine but not in the power category as the Northstar.
How do you remove the front valve cover on a 1996 deville northstar engine?
you dont. a cadillac tech does
Where is the starter located on 1994 Cadillac eldorado northstar engine?
Under top engine cover that says 32 valve Northstar between both cylinder heads. Good luck
Have water leak on a 4.6 32 valve v8 northstar engine in Cadillac deville?
waterpump or radiator hose
2001 cadillac with the 32 valve northstar engine that just shuts down when drivingWhat could be the problemThe car only has 29000 miles on it.?
check the fuel pump
Where is the starter located on a 1993 Cadillac?
The starter on a 1993 cadillac assuming that it has a 32 valve northstar the starter is underneath the intake manifold
Do the motor have to be lifted to change the crankshaft sensors on a 2001 cadillac deville northstar 32 valve?
no it does't
How long does a Cadillac Northstar 32 valve v8 engine last?
This particular engine has been noted for its quality. As long as it is correctly maintained then it should last around 200,000 miles before any remedial work is required.
What does hot water valve do 1976 cadillac?
Keeps engine coolant from going through heater core when it is not needed.
Where is the 1992 Cadillac eldorado PCV valve located?
Assuming it's a Northstar, it is inserted into the valve cover nearest the firewall on the passenger's side near the coil pack.
I noticed that the intake manifold on the northstar v8 and an LS engine are very similar Is it possible to put an intake manifold from a RWD LS engine on a northstar v8?
In a word, no. The Northstar engine is a DOHC 4 valve-per-cylinder engine, while the LSx is a traditional pushrod engine. The ports of the northstar are wider to accommodate 2 intake valves, the ports on an LS are narrower and tall feeding a single, large intake valve. The heads on a Northstar are wider and therefore the valley is narrower. The starter on a Northstar is located in the valley. All of these attributes dictate the design of the Northstar intake manifold which, looking similar on top, is very different than an LS manifold on the bottom.
