Trying to fix a cv axle half shaft your self is difficult. Replace it with a rebuilt or new half shaft. The parts to repair yours would cost you more than a complete replacement does.
YES.
There is 1 behind each front wheel and 1 on the transmission tail shaft if it's a 2-wheel drive. 4-wheel drive will have it on the transfur case.
It will be screewed into the transfur case tail shaft housing. Where the drive shaft slides into it.
its simple its just 4 7/16 bolts on the rear of the shaft and the front just slides out.
Yes you can turn it with your hand when it is in 2-wheel drive ONLY.
If it is a 4-wheel drive theit will be on the rear of the transfur case where the drive shaft goes in it. The 2-wheel drives are on the transmission tail shaft.
Had one built for 1995 Chevy silverado z-71, rear, 65" balanced with my yoke, $275
NO. It has a slip yoke.
You would need a drive shaft from a suburban
I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit
take out the four bolts where the drive shaft meets the rear end,then move the driveshaft foreward about one inch,drop the driveshaft down and pull it out.
if leaking out small hole in middle of front driveshaft yoke, check o-ring in cup on output shaft. have to remove extension housing.