HO2S (A/F) Sensor Heater Control Circuit Low (Bank 2 Sensor 1)
symptoms
Other than the MIL light illuminating you may not notice any performance issues.
cause
A short in the O2 sensor heater circuit or the sensor itself
A faulty O2 sensor heater
Wiring or connectors are broken or frayed to the sensor or relay
Bad PCM or ECM
The fix
Correct wiring short or loose connector found in inspection.
and/or
Replace the bank 2 sensor 1, O2 sensor
Replace PCM if circuit has failed and no wiring issues present, good O2 sensor
This vehicle is still under warranty. Take it to the dealer. I went to the dealer,but they said that I have to pay for everything and even for testing.
Yes provided the voltage is compatible.
Yes, a space heater can be plugged into any outlet. Depending on what else is drawing current on the circuit will govern whether the circuit will trip or not. If the heater is plugged in and the circuit does not trip it can be left plugged as long as it is needed. If the heater trips after a few seconds, then try another outlet.
does the bypass valve on elution heater be open or closed
The clicking noise you are hearing could be the heater is overloading the breaker and it is on the verge of tripping This could be caused by the heater being to large for the circuit. Check the amperage rating on the heater and the rating on the breaker It also cold be the circuit breaker is going bad and needs to be replaced by a qualified electrician These are 2 possible answers you also could have a bad (loose) electrical connection some where in the circuit
Did you reset the GFCI? Any outlet attached to the GFCI's load (output) will not work if the GFCI has no power/is inoperable.The water heater could have a neutral-to-ground short, a type of fault which would be not have shown up on a circuit having no GFCI. That would be a good reason to scrap the water heater if it cannot be fixed! Anyway the best advice is to call in an electrician to run a separate circuit for your water heater.Take the water heater off of that circuit! Nothing else should be on that circuit, and call a electrician to run a separate circuit for your water heater!!! 1500watts divided by 120 volts is 12.5 amps.Always be sure to switch off the breakers at the main panel before you attempt to do any work on any mains power circuit.
Load circuit
In a 97-03, the bulbs are soldered into the circuit board of the heater controls. Remove the heater control assembly and disassemble it to the board. Desolder the bulbs and replace with new ones from either radio shack or corvetteradios.com. The bulbs are 12v but I don't know the wattage. CorvetteRadios has bulbs for the CD player as well which are similarly soldered into the circuit board on the face plate.
Heated oxygen sensor heater circuit malfunction (bank 1, sensor 1): Open or short in heated oxygen sensor heater circuit Heated oxygen sensor heater malfunction (Haynes Repair Manual)
Trouble code P1135 means: Air-Fuel Sensor Heater Circuit Response Malfunction
Trouble code P0135 means:O2 sensor heater circuit malfunction (Bank 1 Sensor 1)
Trouble code P1135 means: Air-Fuel Sensor Heater Circuit Response Malfunction
Trouble code P1135 means: Air-Fuel Sensor Heater Circuit Response Malfunction
how to replace a heater matrix in a toyota previa
Trouble code P1135 means: Air-Fuel Sensor Heater Circuit Response Malfunction
It is the one on the passenger side behind the catalytic converter
Environment Circuit
heater sensor circuit Chevy astro 2000