Chevy Silverado
Chevy Astro
Chevy S-10
How To

How to install a fan belt on a Chevy Astro van 92?

373839

Top Answer
User Avatar
Wiki User
2007-01-15 21:50:19
2007-01-15 21:50:19

There should be a diagram under the hood, or radiator fan shroud, on my 91 awd its on my power steering canister underneath the windshield, just look at that and follow the instructions. hope this helps

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you replace fan belt on 95 Chevy S-10 2.2 engine

User Avatar

pull on your tensioner to remove pressure with a wrench remove belt and reverse

User Avatar

The Villager has an electric fan and does not use a "fan belt".

User Avatar

Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.

User Avatar

a picture of how to assemble a fan belt fro 98 Chevy venture van

User Avatar

Drain the radiator. Remove the fan and fan shroud if needed. Remove the pump belt. Unbolt the pump and remove it. Install the new pump. Reinstall the belt, fan and fan shroud. Refill the system with new coolant.

User Avatar

how to change the fan belt on a 1995 Chevy blazer vortec motor?

User Avatar

If it is a serpentine belt you replace the tensioner pulley

User Avatar

Pull back the belt tensioner and slip the belt off. Reverse procedure to install.

User Avatar

Observe how the belt runs around the pulleys then take a 1/2" ratchet and insert it into the belt tensioner( on top near shiny pulley) and pry back the tensioner. Simply remove old belt and install new one. You will be surprised how easy it is. I hope this helps you. Mark

User Avatar

drive belt for what on this vehicle? do u mean serpentine belt,or fan belt,or timing belt?

User Avatar

Usually a squealing sound upon acceleration , or even just revving the engine in neutral , indicates a worn or loose fan belt .

User Avatar

Easiest way is to: l. Drain coolant by diconnecting lower radiator hose 2. Take off serpentine belt 15mm socket 3. Take off fan. 10 mm wrench. Keep upright on ground 4. Take off fan shroud. two halves separate. 2 bolts each side 5. Take off two hoses to pump 6. Unbolt water pump 1/2" socket and clean surface 7. Put gasket seal on new pump and install 8. Install two new radiator hoses 9. Install fan shroud 10. Install fan 11. Install serpentine belt 12. Add coolant

User Avatar

The serpentine belt has a tensioner that you nust pry up to remove the belt. There should be a schematic of the routing of the belt on the fan shroud. If not, draw one before removing it.

User Avatar

I have a 1996 Astro van and I'm having trouble too. My fan motor sticks. It has for a while. Its not the heater but the fan that has draged. I can get out and pound on the casing, and sometimes it starts up.

User Avatar

the eng.size,is there a smog pump.is there air con.tell auto parts store this information

User Avatar

REMOVE THE SINGLE DRIVE BELT, THEN REMOVE THE 4 MOUNTING BOLTS BETWEEN THE FAN AND THE BELT PULLEY. THE FAN MIGHT NEED TO BE WIGGLED OFF

User Avatar

Loosen the component slide it towards the engine to lossen the belt, remove belt. Install in reverse. If the fan is your problem it is held on with 4 small bolts, remove them and the fan. P/S you should be able to work the belt around the fan blades without removing the fan. On_mitch

User Avatar

Remove the wiring harness or the fan motor belt, depending on the year of your Chevy Cavalier. Remove the fan motor retaining bolts. The fan motor will come off.

User Avatar

Look under the hood for the radiator fan. The fan is mounted to the pulley at the front of the water pump.

User Avatar

follow the instructions on the fan shroud

User Avatar

i will find out 4 u my dads a mechanic


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.