GET A KNIFE AND CUT IT OFF
i beleave there are clips under the seat you might have to take the seat out and tip it over and there should be plastic clips that you can remove
You have to remove the entire headlight assembly. Glass cover clips on with plastic clips. Remove and install CAREFULLY as glass breaks easily.
There are no 'clips'. The filter is on the passenger side under the plastic cover just below the wiper. Remove plastic cover's weatherstrip; Remove plastic cover's center retaining bolt; Remove plastic cover's plastic passenger side 'screw'; Lift out passenger side cover; Filter is in the well. Pull it out. Installation is reverse of removal.
this probably isn't very helpful, but 1.remove the rear seat 2.there will be black clips that hold on the plastic panel (speaker is located behind the panel) remove the clips then the panel 3.unscrew the speaker and clip the wires this probably isn't very helpful, but 1.remove the rear seat 2.there will be black clips that hold on the plastic panel (speaker is located behind the panel) remove the clips then the panel 3.unscrew the speaker and clip the wires
yes, it is,,, just pop out. you need remove the hard plastics clips.
use a torch to melt out the plastic then remove the clips(on the inside) and remove as normal
there are two Phillips screws in the plastic bezel and then two push in clips that are part of the plastic bezel.After you remove the plastic bezel there is two screw on the top and two on the bottom of the metal retainer ring that hold the light
You will have to access the fog light bulb from below the vehicle. Remove the plastic clips from the wheel well cover extension that is below the fog light. Once the clips are out and the plastic cover is pull down, you should be able to see the back of the fog light. You can try to replace the fog light bulb now or remove the two 10mm bolts and slide the fog light assemble out through the front of the bumper. Turn the cover of the rear of the fog light and replace light.
Unfortunately, you have to remove the door panel cover. There are three or four screws and several pop-clips, but it is actually pretty simple. To remove the door panel, you have to disconnect the power connector and the speaker (just clips). Hope that helps
They are in the center of the Valve cover, under the plastic "chunks" that are the ignition coils. You might need to remove the plastic engine cover first. There are several plastic clips you need to turn part way to remove this part.
It was easy,remove bat, unplug wiring,pull 2 clips and push out the bottom mounting plastic and remove assembly.save clips for use on the new assembly