On the outer side of the blower housing there is a small square tab, about 1/2 inch by 1/2 inch in size. Pull that tab down towards the floor board and turn the blower moter about and inch and it will release itself from the housing
Remove the wiring harness from the back of your 2005 Chevy Cavalier heater blower motor. Remove the heater blower motor retaining bolts. Remove the heater blower fan.
the blower is located behind the clove box, you have to remove the clove box to remove the blower.
Remove the instrument panel silencer from the passenger side of the instrument panel. Disconnect the wire harness connector from the blower motor. Remove the three screws that secure the blower motor to the HVAC housing. Remove the blower motor from the HVAC housing by rotating and tilting the motor as needed for clearance of the blower wheel....
To replace the blower motor 2005 Ford Focus, you have to see the attached instructions on the manual. A screwdriver will help you remove the screw.
Remove the two screws that holds it in place next to the blower motor on the passengers side under the dash...............
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............
The blower motor resister is located just to the left of the blower motor on the passengers side right below the blower motor return air tube.......
The 2005 Lesabre has the blower motor mounted under the dash. It is under the glove box on the firewall behind a panel.
Replace the blower motor resistor.
The 2005 Ford F1 50 pickup truck blower motor resistor pack can be found on the firewall in the engine compartment. The blower motor resistor pack is on the passenger side of the firewall.
i Anybody who tells you to remove the four screws to get to the blower motor on the SIERRA is FOS! First remove the cover under the glovebox- No you don't have to remove the glove box. If you can remove the 2 easy ones using 9/32 and a stubby, the third one you can loosen and just let the cover drop. Now disconnect the resistor from the motor. Its a clip so do this in the daytime. Locate the blower motor. Its under the glovebox. Look for the tab on the top of it, by sticking your head in there. rotate the blower motor clockwise and it will drop right out. Don't lose the screws, the hardest part is putting it back together.
Resistor or blower motor power module.
My 2005 does the same thing, just found out it's the blower motor control module. Hope that helps out!!
Blower resistor is behind the blower motor up against the firewall you can see wires hanging down from it. (Mite be called blower control module in 2005 models.)
The front blower motor is attached to the bottom of the HVAC housing, under the dash, on the driver side. The rear blower motor is inside the trim panel, on the right rear of the van.
you need a new blower motor resistor with auto temp control
Under the passenger side dash. It's awkward to get to, but it's there.
Under the passenger side of the dash
A heater blower in a 2005 Chrysler Pacifica is a complicated process. To get this [project done, you will have to go to a mechanic and have it done.
The front blower motor for a 2005 Ford Freestar is located in behind the glove compartment. To gain access you need to completely drop down the glove compartment. You can do this by just pushing in on the tabs (upper location, rear glove box) that hold it in place. Then do the following: -Unplug wiring harness that sits directly in front of blower motor. (allows more room to remove part) -Unplug power supply to blower motor. -Remove 3 screws that hold the motor in place. Suggest you use a socket wrench with extension. That's pretty much it. You may have to move the blower motor around a bit in order to extract it, however it's not too difficult. Depending on your comfort level to perform this task, removal and installation should only take 25 to 45 minutes.
The blower resistor assembly is located on the heater case to the right of the blower motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
If you are sure that everything is working correctly then check the ground going to the blower motor assembly.............. Which goes through the blower resistor.
Behind the glove box.
It is under the dash on the passenger side.