Want this question answered?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
yes
its right behind the harmonic balancer....so you will have to remove the h.b them remove the crank sensor...
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
YOUR LOCAL AUTOPARTS STORE WILL RENT YOU A PULLER AND SHOW YOU HOW TO USE IT.
The bolt is stuck and can't seem to come off.
It is located behind the harmonic balancer on the front of the engine. You'll need a special puller to remove the balancer.
You will need to go through the passenger front wheel well (wheel off). Remove belt, remove pulley/balancer with a balancer puller tool. Air tools make this job MUCH easier.
it is behind the harmonic balancer.
I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.
Its refered to as a harmonic balancer, and you have to have a special tool to remove it called (surprisingly) a harmonic balancer removal tool. The installation tool is a good heavy hammer and a block of wood. If you dont have access to this special puller, you can (and likely will) damage the harmonic balancer, so it would be best in that instance to take it to your local mechanic and ask him to take pull it off for you.
Behind the harmonic balancer.