Call the water board, if you can't turn the pressure down on the boiler.
There is usually a main water valve that comes into the house, locate this valve and turn it down. Installing a pressure reducing valve after water main valve will allow for adjustment of water pressure to proper setting.
no
How to reduce your water pressure to your taps if you have a high mains pressure or an unvented cylinder such as a megaflow, boilermate ect. Reducing water pressure in your home can be done in several ways, my video demonstrates a few. Some people turn down the isolation valves or main stopcock which is not advisable, as it can produce noise, water hammer in pipes /taps and can damage the valves and stopcock.
That squeal you here is a very acute vibration that comes from the washer as it touches down on the base of the tap, it is normally caused due to very high water pressure.
Call the water board, if you can't turn the pressure down on the boiler.
By reading and following manufacturers directions of course
There is usually a main water valve that comes into the house, locate this valve and turn it down. Installing a pressure reducing valve after water main valve will allow for adjustment of water pressure to proper setting.
Someone may be illegally tapped into the same main
turn up the water pressure
Possibly, the water pipe feeding from the geyser to that tap has not been secured down properly and is not rattling, or you may need to turn the pressure down on the pressure valve feeding the geyser on the cold line to reduce the noise.
no
No. It takes much more than water pressure to turn on the water faucet. At most, there is a leak if anything at all.
There is pressure in all water because of the weight of the water above it pressing down
turn down the temperature increase pressure
Pressure certainly does increase in a water line going down hill. This is because the weight of the water pulls it.
Yes, the more the water the greater the pressure of all the water pushing down on other water.