I would personly take it to a garage or get the garage to come to you something must be wrong with it but there could me many reasons/answers. Hope this helps B x
does the motor spin..ie..crank? if no possible locked up engine..try spinning it by hand..correct size socket on front crank bolt turning clockwise.. possible bad starter motor does the starter engage when the key is in the crank possition. if the motor does crank your looking at a fuel or ignition problem
The problem is possibly your crank seals. When the motor is cold it runs ok but as it comes to normal temp it craps out , more than likely its your crank seals, perhaps base gasket.
starter is bad Gen-R
If you battery has plenty of power, either faulty contacts in ignition switch or starter motor, or faulty starter motor.
Depends on the motor, 4cyl or V6, but it could be the ignition module, or the crank sensor
if the motor is bad or it's an electrical problem you can remove motor and crank shut manually, not sure what kind of tool you might need
A trick question?? the obvious #1 ans.-- a battery problem, then on to a cable from the batt. to the starter, then a bad starter ,then onto a problem inside the motor,(Like the timing chain or anything within the path of the motor's moving parts.)
It means there is a problem with either one that comes on.
It does not have a crank sensor.
The Crank Case is dirty. Use a good Crank Case cleaner to solve problem like Motor Medic Motor Flush. Warm engine 5 minutes and let clean out for 5 to 7 minutes. Then drain and use fresh oil.
A hole in your block comes from massive mechanical failure. Mostly a broke rod or crank. If you have a hole in your block, you need a new motor.
NO, my god no