answersLogoWhite

0


Best Answer

Generally, if the motor is working on windshield wipers, the problem is electrical. Check the fuses and the wiring to see if something needs replaced.

User Avatar

Wiki User

โˆ™ 2014-09-18 00:22:00
This answer is:
User Avatar
Study guides

Where I can purchase purchase HID Fargo ID card in Dubai

โžก๏ธ
See all cards
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
No Reviews

Add your answer:

Earn +20 pts
Q: If the windshield wipers on a 94 Sable are not working and the motor is OK what else would one need to replace and how?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix the windshield washer tubing on a 1998 sable?

Replace it with new tubing.


How to replace a windshield sprayer NOZZLE on a 1999 sable?

Unless you have lost the nozzle there is no reason to ever replace it. It is probably stopped up. Take a needle and unstop it.


How much does it cost to replace a Mercury Sable windshield?

I had mine changed by American Mobile Glass and it cost $145.00 and they came to my job and did it.


Can a Ford Taurus 1992 windshield fit in to a mercury sable 1996?

No, a Generation 2 (1992-1995) Taurus/Sable Windshield will NOT fit a Generation 3 (1996-1999) Ford Taurus/Sable.


Will a windshield out of a 1999 Taurus fit in a 1998 mercury sable?

Yes, it is identical.


How do you replace a horn in a 1998 Sable?

1999 mercury sable horn replacement


What could be going on a 1991 Mercury Sable Wagon after the vehicle warms up the windshield wipers have worked then stop working and after banging the steering wheel work sporadically?

AnswerBecause you can hit the steering wheel and it seems to make a difference, I would suspect that the wiper switch is on a wand near the wheel and it is probably going out. This type of problem can be hard to find and dangerous in a rainstorm.(not to mention frustrating) I would replace the switch. See "Related Questions" below for more


Why do the wipers and windshield washer not work in a 1995 Mercury Sable - Ford Taurus?

2 things the wipers and washers have in common:The fuseThe control switch - on the multi-function switch / turn-signal stalkHopefully it'll be the fuse, but not uncommon for the multi-function switch to go bad too.See "Related Questions" below for more specifics about both


Mercury sable rack and pinion?

what is the cost to replace the rack and pinion on a 1994 mercury sable


How do you replace the windshield wiper fluid hose on a Ford Taurus - Mercury Sable?

take pair of plyers and grap the clamp and pull toward the center of the hose you will need to do this twice then put the new one on withthe same clamps the hose should come out of the bottmom of the windshield reservor


How do you replace the cabin pollen filter on a 1998 Mercury Sable?

1: Remove the car's windshield wipers. One is longer than the other, so mark which arm goes on which side of the screen if you've not done this before. A sticky note does the trick. 2: Open the hood. 3: Remove the black plastic trim that sits across the bottom of the windshield. (You cant get the trim off without removing the wipers) 4: The pollen filter is located under left hand corner of the windshield, assuming you have the hood up and are viewing the engine bay from the front of the car. It's tucked away under the shelf-like structure protruding from the base of the windscreen. It's not obviously visible because it's obscured by a black plastic cover which keeps water off of the filter. Pull the plastic cover off and remove the filter. 5: Replace the filter and cover. It's fiddly. Patience and lots of wiggling of the plastic cover is needed. It's robust and flexible, so don't be too gentle with it. 6: Replace the windscreen trim and your windshield wipers - job done. Good luck!


2002 Mercury Sable autolamp sensor?

My auto lamp light sensor is not working on my Mercury Sable 2002. Why?

People also asked