check and make sure u changed turn signal falsher. there are 2, 1 for turn ,and 1 for hazards. other than that, it sounds like your turn signal switch is broken
check relay module under the dash on some models the hazard and turn signals are built together and painted yellow
Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,Fuse, flasher, switch, bulbs, wires, ignition not on, dead battery,
There is a separate flasher for the turn signals that looks the same as the 4 ways. Your's is probably bad. Check your owners manual or your Chrysler dealer for its location under the dash.
The turn signal flasher is located in the light control moduel. That is located under the steering column. If you are having problems with turn signals, check the fuses before changing the light control moduel.
the flasher that causes the turn signals to flash But where is the flasher located on this car?
There are two flashers, one for the hazards and one for the signals.
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
There is a flasher for the turn signals installed under the dash on the driver side. It will be just to the right of the steering column.
probably the flasher unit or the multifuntion switch in the steering column but i think probably the flasher unit
There are two relays, one for the emergency flasher and one for the turn signals. Replace the Flasher Relay for the turn signals, it is defective.
If the problem started after you replaced a fuse, you need to check that the fuse is good and installed properly.
did you pit it in up side down?????????????????????????????