answersLogoWhite

0


Best Answer

There is a oil pressure sender on the oil filter/cooler assembly. It works between 1.2 and 1.6 bars. I have never heard of a safety cutoff or anything like that. If you go to a VW dealer you will find that the pressure sender part number was revised 3 times. Problems eh. Good luck.

User Avatar

Wiki User

โˆ™ 2007-08-18 23:35:12
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides

๐Ÿ““
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Is There a low oil pressure sensor switch in the 2000 VW Jetta that cuts the motor off when there is little or no pressure?
Write your answer...
Submit
Related questions

Where is the oil pressure sensor in a 1999 vw jetta?

its located on the oil filter housing....


What causes oil pressure sensor to beep in 1997 jetta?

The oil pressure sensor could be defective as they can be clogged over time. You can use an oil stabilizer or replace the sensor if the oil stabilizer does not fix it.


Where are the oil pressure sensors on 1995 VW Jetta GL 2.0L?

The oil pressure sensor on a 1995 VW Jetta GL 2.0L is located on the bottom of the engine, near the oil pan. It provides oil pressure information to the vehicle's computer.


Oil pressure sensor location on 2001 jetta 1.8 turbo?

Typically, the oil pressure switch is located on the oil filter adpater near the bottom of the engine on the front side. If your car doesn't have one, there will be an aluminum hex-wrench plug in its place.


Where is the backup light switch in a 1997 VW Jetta?

where is the backuo light switch in a 2001 jetta ?


Why would the computer on your 2006 vw jetta gli say Stop Oil pressure off?

Computer may be malfunctioning. The oil pressure sensor might not be operating properly. The sensor might need to be changed.


How do you replace crankshaft sensor on a VW jetta 2.5l 2006?

where is the crankshaft position sensor on 2.5 liter vw jetta


What does P0120 code meanfor 1996 Jetta VR6?

Trouble code P0120 means:Throttle/pedal position sensor/switch A circuit malfunction


What does P0120 code mean for 1996 Jetta GLX?

Trouble code P0120 means:Throttle/pedal position sensor/switch A circuit malfunction


Where is the speed sensor located on the jetta?

The speed sensor in located in the front of the motor. You can find it near the transmission and the engine split line on the Jetta.


How do you fix a 99 Jetta VR6 shift solenoid electrical sensor?

The solenoid electrical sensor is responsible for allowing a shift in gears. The sensor in a Jetta VR6 can be fixed by a dealer mechanic.


Where is the thermo fan switch on 2003 VW Jetta?

It is located at the bottom drivers side of the radiator. It is a round sensor with large hex head that screws into the radiator. Follow the wires from the cooling fans to the sensor.


Where is the speed sensor in a 98 jetta located?

The speed sensor on a 98 Jetta is located near the brake setup. It is on the passenger wheel area mounted to a bracket.


What does code P0121 mean for 1996 Jetta GLX?

Trouble code P0121 means:Throttle/pedal position sensor/switch A circuit range/performance problem


Where is the reverse light switch located on a 99 vw jetta with a stick shift?

where is the reverse light switch located on a 2002 jetta with a stick shift


Why does the oil pressure sensor alarm on 1996 volkswagen jetta keep sounding after replacing oil pump oil sensor oil pan gasket and oil filter housing?

Because it is not a good car!


Where is idle speed sensor for vw jetta 96?

The idle speed sensor tells the onboard computer how fast your engine is idling. The location of the idle speed sensor on the VW Jetta is on the actual throttle body.


98 jetta cooling fans won't shut off?

Idk. I replaced the thermal sensor on mine I also have a 98 jetta didn't work. So it's either the fan switch or the control module fan relay.


Why would the heater wipers and lowbeams on a 1992 VW Jetta not work but when holding highbeams on everything works?

I had a similar problem with my Jetta. It turned out to be the ignition switch. It takes a little work to change it as the steering column has to come out to disconnect the ignition switch from the bottom of the tumbler( where the key goes in). i


What could cause the low oil pressure light to come on in an 01 vw jetta other than little or no oil?

bad oil pressure sending unit


How do you replace a crank sensor on a 2004 jetta?

How_do_you_replace_a_crank_sensor_on_a_2004_jetta


Knock Sensor location in VW Jetta?

A knock sensor sends a voltage signal to regulate ignition timing. In a Jetta, it is typically located under the air intake manifold.


How to replace camshaft position sensor for vw jetta 1999?

how to remplace position of oxigen sensor


What is engine code p0322 on a 2002 vw jetta?

Crankshaft Position Sensor (CKP Sensor)


Does a 1995 jetta have a neutral safety switch?

yes