Chevy Silverado
Pontiac Trans Am
Ford Bronco II
Chevy 350

Is there a 2 speed rear end for an 88 Chevy 2500 with a 350 and a 4 speed manual trans?

676869

Top Answer
User Avatar
Wiki User
2011-09-13 05:36:49
2011-09-13 05:36:49

Very unlikely Most likely have to change gears in rears

AnswerI worked at a place that had a small Chevy flat bed and it had a 2 speed rear it was in the 80s the cab was small like a pickup -- rear should fit if u find one let me know the gearing i would like to put one in a new dodge for drag racing
1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It is a special manual trans fluid for the NV 4500 transmission that is available at both Dodge and GM dealers.

User Avatar

i have a 96 suburban with the same engine,owners manual says 7500 lbs (4l80 trans)

User Avatar

Yes, there are wiring diagram available for a 2007 Chevy 2500 Duramax. These are available in the cars maintenance manual.

User Avatar

No difference in the engine. It is all in the trans and the rearend

User Avatar

That requires an OBDII engine scanner to read the transmission codes.

User Avatar

As far as I know GM did not start using gov's., until mid 2000, with the new motors. It is part of the computer.

User Avatar

A manual transmission does not have a neutral switch. It has a clutch switch, which is on the rod that attaches to the clutch pedal.

User Avatar

check pig tail at speedsensor at rear at trans case or trans. or if that fails change vehicle speed sensor

User Avatar

its located in the transmission, drop the pan

User Avatar

What is the horsepower of a 2000 chevy 2500 7.4

User Avatar

Will a 2000 chevy 2500 bumper fit a 2005 chevy 2500

User Avatar

Manual holds about 5 quarts Auto dry fill is about 16 quarts

User Avatar

Need to check are replace the 4x4 actuator in the FRONT differential.

User Avatar

No you can not. The 98 computer is not programed to shift the 89 transmission. Besides that your wiring harness on the 98 will not hook up to the 89 trans. You need to go back with the factory 4L80E trans. That belongs in the 98.

User Avatar

On the very back top side of the transfur case.

User Avatar

Refer to the owners manual. There should be diagrams in there for the wiring order.

User Avatar

If it's an automatic, you have a 4L80E. If it's a manual, it's an NV4500.

User Avatar

Power (SAE net) * 215 bhp @ 2600 rpm - 49 state manual * 180 bhp @ 2500 rpm - all auto. trans * 180 bhp @ 2500 rpm - CA man. trans Torque (SAE net) * 440 lb-ft @ 1600 rpm - 49 state manual * 420 lb-ft @ 1500 rpm - all auto. trans * 420 lb-ft @ 1500 rpm - CA man. transCompression Ratio: 17.5:1

User Avatar

There is no input speed sensor. The output sensor is located on the driver side rear of the auto trans case.

User Avatar

You can switch the rear end from a Chevy 1500 with a Chevy 2500 rear end with minimal effort. Both have similar components but the 2500 offers increased durability.

User Avatar

allison 1000 if it is before 2006 (5 speed). in 2006 they switched to the 6 speed allison 2000


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.