Should be the same circuit for parking/tail/dash lights
The license plate light circuit is protected with the tail light circuit fuse.
the bulbs could be out. if it has a trailer hitch on it and it was installed after market (not by the dealed), a lot of the time the marker lights to the trailer are spliced in to the licese plate lights and the type of conector that are used are prone to corosion. if that is the case just splice it together after the corroded wirer is remove and seal it electrical heat shrink.
Changing the license plate bulb on a 2002 Lincoln LS is quite simple. You must first remove the license plate first. Then unscrew the old bulbs and screw in your new ones.
It attaches to throttle plate (next to throttle cable) to cruise control unit.
Almighty1
The license plate lights are located just above the license plate. Open the tail gate part way to make removal easier (unless you enjoy squatting). Remove the Phillips screws and replace the affected bulb.
to wire the license plate lights you must have lights and wire them to the scooter.
Just unscrew the two screws that hold on the small clear lens and pop the bulb out.
No, the license plate light is wired in with the rear tail lights, not the brake lights.
yes 2002 Ford Focus do have 2 lights on license plate
The license plate lights are not in a separate fuce by it seft. They are the same as your side marker lights. So, check if your side marker lights are working and if they are them is a bad license plate light bulb.
That would be the lights that illuminate the rear license plate.
Check your fuses.
Yes, they should be identical.
yes.
Radio fuse
Just unscrew them, there's no trick to it. If they're stripped pry under the edge with a knife to get them to back out.