It could be the turn signal bulbs, some vehicles use separate bulbs for the hazard and turn signals.
It could also be a bad switch or wires for the turn signals.
my turning signals dont work on my 91 integra LS. They were working a day before. so the next day they werent. I also had battery problems but i had checked every single fuse and the fuses arent burn. My turning signals do not work what so ever.
your fuse is to strong try a lower fuse or some other one is wrong sending too match power that why to blows, or is your headlight cracked?
If you haven't checked the fuse box do so, it's under the dash on the drivers side. If the fuse isn't blown, don't know
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
Blown fuse or bad flasher unit. Often, cars use different flasher for the turn signals and the flasher, so it is possible for the hazards to work and not the turn signals.
fuse or blub is out or blown, or wiring is bad, or the relay is bad.
If the turn signals are inoperative check the hazard switch, if the hazards don't work replace the hazard switch, the signals will start working. if the hazards are ok ,the turn signal switch may be bad.
More than likely the flasher relay is defective, replace it.
It contains two relays, one for hazard lights and the other for turn signals. The one for the turn signals is defective and must be replaced.
Assuming you checked the bulbs, the signal/hazard switch assembly could be shot. Also, using a test light, check the fuses to see if they are getting 12V.
Well so far I have found that when I turn my headlamps on and switch to the high been and then use the rocker switch for the hazards, it will allow for my turn signals to start working again.
Turn signal flasher