Fuel Pumps
Mazda Trucks
Ford E-150 Van
Ford Expedition XLT

On a Mazda 1999 b3000 what is the fuel reset light for and where is the reset button?

555657

Top Answer
User Avatar
Wiki User
2005-11-22 00:27:55
2005-11-22 00:27:55

The fuel system is pressurized on fuel injected engines. If you were in an accident and the fuel pump still running, it could spray out fuel and feed a fire. The fuel reset switch detects a sudden jolt (hard!) and trips. You just reset it by pushing the button on top. On my 99 B3000, its on the firewall under the glovebox, and has a red top. HTH

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Mazda truck b3000 where is the fuel pump reset switch located

User Avatar

The Mazda Protege fuel reset button can be found on the firewall in the engine compartment. The reset button will be in the middle of the firewall.

User Avatar

The fuel reset button for a 1999 Mazda 626 is located inside the trunk of the vehicle. It will be on the left side close to the outer left tail light.

User Avatar

in my 2000 b3000 it is under the passenger glove box next to the fuel pressure release valve.

User Avatar

On a 1996 Ford Ranger ( ASSUMING it is the same setup on your 1996 Mazda b3000 ) the fuel pump shut off switch ( inertia switch with the reset button on top ) is located in the front passenger footwell , in the corner , above the carpet and below the dash

User Avatar

Reset the change oil light on Mazda 3

User Avatar

how do i reset an airbag light on 2004 mazda premacy

User Avatar

It is not equipped with a fuel pump reset button. Check the fuse and relay.

User Avatar

The light is reset with a scan tool after the repair. There is not a button.

User Avatar

You can reset the ABS light in a 2000 Mazda 626 by unplugging the battery cables. You can also reset it by connecting a diagnostic tool to your car.

User Avatar

There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.

User Avatar

There is no reset button for the check engine light. It must be reset with an OBD scan tool.

User Avatar

If you fill your tire to right PSI the light will reset itself.

User Avatar

Lots of patience! Hold the reset button, then when it says"to reset hold reset button" let up briefly and hold it! Lots of patience! Hold the reset button, then when it says"to reset hold reset button" let up briefly and hold it!

User Avatar

hold the reset button and the trip/ odometer button at the same time or some combo of the reset button and another hour or min button.

User Avatar

There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.

User Avatar

Press in and hold the trip reset button. Switch on the ignition keeping the button pressed.

User Avatar

I found a reset button under the dash board. You may want to look there first.

User Avatar

If you mean the light it should reset itself while driving

User Avatar

Press and hold the odometer reset button, & turn on the ignition switch without starting the car. After around 5 seconds the light will reset. Release the odometer reset button and turn the ignition off.

User Avatar

if the service light has come on, you can reset this by pressing the odo trip meter reset button on the dash. that's the one you use to reset the trip counter to zero. put key in ignition and turn to position 2, press and hold reset button for 10 seconds. light will go out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.