answersLogoWhite

0


Best Answer

yes that bolt is keep the balencer mounted to the crank shaft

User Avatar

Wiki User

โˆ™ 2008-01-06 17:24:34
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Should ther be a bolt in the center of the balancer on a 91 3.8 buick lesabre?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1995 buick lesabre crankshaft senseor location?

it is behind the harmonic balancer.


How do you change the harmonic balancer in a 1994 buick lesabre?

I tried to change the harmonic balancer of my biuck lesabre 1994, but i can't remove the old one, the bold in the center is very , very tight and i don't know the type of screw, right or left turn.


How do you change harmonic balancer on 1991 buick lesabre?

The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.


Where do you find the crank position sensor for a 1997 buick lesabre?

its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it


Where is the computer in a 1994 Buick lesabre?

On my 1994 Lesabre it is under the dash about center at edge of carpeting


How do you replace a crank sensor on a 1995 Buick Lesabre?

Remove belt, balancer bolt and get a balancer puller to remove the balancer. Unbolt and unplug sensor to replace it. An air impact wrench that is strong will get the bolt loose.


How much should it cost to replace ball joint for buick lesabre?

Cost on replacing ball joints on a 2001 Buick lesabre


1997 BUick LeSabre Custom location of crankshaft sensor?

the crankshaft sensor is located behind the harmonic balancer on the ft timing cover


Where is the Crankshaft sensor on a 2000 lesabre?

The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.


What is the torque spec for front center bolt?

97 buick lesabre center front wheel bolt size


Why would a 92 Buick LeSabre not run turn over after Serpentine belt shreds?

probably damaged the crank sensor, or the tangs on the harmonic balancer


Why won't my 1988 Buick Lesabre start?

Because its a 1988 Buick LeSabre

People also asked