The front blower on your 2003 Durango only works on high. Is there a repair for this or do you have to replace the blower?

Blower resistor. I have an 04 that does the same thing. Bad connection between the resistor and the plug for me. Big topic though for durango those resistors.

That's too bad

One for front, one for rear. One for front, one for rear.

2004 ford expedition front blower not working

You do not repair them you replace them.

Its your Blower resistor! Its located on the passenger side underneath the dash board. I had to change mine in my 02 Durango. It takes about twenty mins and cost about $40.00 buck. You have to buy it at the dealer.

how do you replace a resister on a front heater blower on a 2006 chrysler town and country touring with a 3.8 motor

under the front passenger seat/ right under the glove compartment

Check the resistor pack, blower speed resistors, low right side under dash, just above foot area, for a bad , burnt connector. Ebay had a repair kit listed to repair the problem. Easy to do and can save $200 if you do it yourself.

They're separate blower systems. Have you checked the fuse?

In most cases the blower motor resistor is the solution. But you need to have a repair shop check it out before you buy something that you may not need.

Check the Blower resistor behind the passenger glove box. I had to replace mine this winter.

its located under the glove box....only 3 bolts holding it in place...its really easy to change

if you have a 2003 Chevy Trail blazer and you need to replace the resistor for the rear blower, the one under the passenger side dash is the one that controls the front and rear blower.

did you ever get an answer? i found the 2 front screws holding the blower, but can't see what is holding the back of the fan in place.

Looking at the picture in my Haynes repair manual it looks like the blower motor resistor is in the engine compartment mounted just to the right of your blower motor when looking from the front of the Explorer - Helpfull

Remove the wiring harness from the back of your 1993 Chevrolet Camaro blower motor. Remove the blower motor retaining nuts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.

Begin by removing the wiring harness from the back of your blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.

The front blower resistor on a 98 Dodge Caravan is replaced by removing the cover and disconnecting the wiring harness. The resistor can then be pulled and a new one put in its place.

The blower motor resistor is located under the front dash on the passenger side of the truck. It is a fairly simple job to replace...maybe 15 minutes. The blower motor resistor is located under the front dash on the passenger side of the truck. It is a fairly simple job to replace...maybe 15 minutes.

safe lite repair safe lite replace

Find where the fluid is coming out and repair/replace it.

No, just replace it.

I had this happen on my 1999 durango. The front blower was not working but the rear blower was. The problem was a dry- rotted wire that is connected to some part of a blower connection located about 3-5 inches to the right of the distributor. The connector has a wire that connects to the bottom portion. The connector is on top and the wire is beneath. Look on the right side of your distributor…

Remove the wiring harness from the back of your 1980 Chevy Camaro heater blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install the new blower motor.

The front axle on a 2001 Dodge Durango will cost about $100. Labor averages about $80 to $100 an hour for about 4 hours. Additional parts might be tie rods and ball joints for another $200. The total might be $800 or more after taxes.

Disconnect the battery and remove the glove box, lower finish panel and ECM. Disconnect the blower motor wire harness and the three mounting screws.. Remove the blower motor.....

I have a 2001 Dodge Durango SLT with the 5.9L engine. The most common problem I've had with the front blower is that it will fail completely or only the high setting will work with the heater or AC. This is caused by a blower resistor switch failure. The resistor switch is located under the passenger side of the dash above where a person's feet would rest. It is most difficult remove and install, but…

Remove the wiring harness from the back of your 1999 Chevy Monte Carlo blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.

Remove the wiring harness from the back of your 1986 Lincoln air conditioning blower motor. Remove the blower motor retaining bolts. Remove the fan on the front of the blower motor. Reverse the process to install the new blower motor.

How do you replace front Brake Pads on E300TD

replace the seal

The 2008 Dodge Durango has 58.8 in. of front hip room.

The 2007 Dodge Durango has 59.4 in. of front shoulder room.

The 2004 Dodge Durango has 59.3 in. of front shoulder room.

The 2007 Dodge Durango has 41.4 in. of front leg room.

The 2009 Dodge Durango has 59.6 in. of front shoulder room.

The 2009 Dodge Durango has 58.8 in. of front hip room.

The 2011 Dodge Durango has 57.0 in. of front hip room.

The 2011 Dodge Durango has 58.5 in. of front shoulder room.

The 2002 Dodge Durango has 57.6 in. of front shoulder room.

The 2011 Dodge Durango has 40.3 in. of front leg room.

The 2014 Dodge Durango has 58.5 in. of front shoulder room.

The 2011 Dodge Durango has 39.9 in. of front head room.

The 2013 Dodge Durango has 40.3 in. of front leg room.

The 2012 Dodge Durango has 40.3 in. of front leg room.

The 2006 Dodge Durango has 41.4 in. of front leg room.

The 2002 Dodge Durango has 56.9 in. of front hip room.

The 2012 Dodge Durango has 39.9 in. of front head room.

The 2006 Dodge Durango has 59.4 in. of front shoulder room.