When I did mine, I believe I was able to do it with the glove box door removed. It was tight, but I got it down thru that space.
You must remove the glove compartment door to access the blower motor. On top of the blower motor will be wires connecting to the top. Release the connecter and let it dangle. Then using a screwdriver, remove the blower resistor on top, where the wires connected, and replace with a new resistor.
The blower motor resistor on a 1993 Nissan Altima is behind the glove compartment on the passenger side of the vehicle. To access the blower motor resistor, the glove compartment can be removed by lowering the bottom as much as possible and removing it from the hinges.
The blower motor resistor pack is accessed from inside the vehicle, not from the engine compartment. Exactly where it is I cannot say. Follow the wires from the blower motor and you will find it.
the blower fan resistor is located in behind the glove compartment to the left of the blower motor. you have to remove glove compartment to get at resistor.
To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.
On a 1996 Ford Ranger : The blower motor resistor is in the engine compartment It is below and to the drivers side of the blower motor
Replace blower motor resistor usually located in the duct work or out in engine compartment in ductwork by heater motor.
How do you replace a fan blower resistor on a vauxal Corsa?
the blower resistor is along the firwall under the hood, on the right side of the engine compartment. it is directly behind the battery, so you may have to remove the battery to get good access.
you have to access the blower through the glove compartment. open the compartment and press the tabs on the sides in the back of the compartment. look inside and the bottom right and you will see the blower motor, remove the three screws and the wire harness, replace impeller and replace motor.
The year, make and model info would help but in most cases the blower motor resistor can be found close to the heat blower motor. So locate the blower motor and the resistor should be very close to it.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.