0
WHY IS MY 1988 tornado instrument panel comes on and goes off?
BROTHERBOB
I've had the same problem. This is the second time it's happened to me. Last time? It was the central power supply (or a power supply of some sort, but I think it was "central power supply"). It's probably the same thing now.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove the instrument panel on a 1988 ford ranger xlt to replace panel lights?
with a hammer
Where is the fuse panel box located on a 1988 Lincoln Town Car?
Behind LH Side Of Instrument Panel
Where can you buy an instrument panel for a 1988 Chevy Silverado?
any good music shops
Where is the horn relay on a 1988 corvette?
it is located behind instrument panel on top of radio.
Where is the instrument panel light bulb located in a 1988 Ford F150 truck?
There are quite a few of light bulbs on the instrument panel. You get to them from the back of the panel. Some instrument panels can be disconnected and pulled forward enough to get to the back, other panels have to be worked on "in place".
The instrument panel does not light up nor does the gauges work in my Audi TT need help?
the instrument panel deos not work all the gauges on my 1988 Audi 5000 cs
What would cause the headlights and the instrument panel lights not to work at the same time on a 1988 Chevy S10?
Faulty ground to the dash.
When was House Tornado created?
House Tornado was created in 1988.
Why would a 1988 Chrysler Le baron instrument panel quit working?
There is a 5 amp fuse in the upper right corner of the fuse panel by the drivers side left knee. I believe it is fuse #13. This fuse provides power to the dash instrument cluster.
Where is the ecm in a 1988 olds cutlass ciera?
The Electronic Control Module (ECM) is located under the right hand side of the instrument panel.
1988 Dakota heater core replacement?
To replace a 1988 Dakota heater core, first discharge the A/C. Then remove the lower instrument panel before removing the heater box unit.
How do you read fault codes on an 1988 toronado?
If your model has the digital heater/AC control panel, turn the ignition switch to "on" and then press the heater control panel's "off" and"warm" buttons at the same time for 5 seconds or so. The instrument panel will then display any codes.
