0
It is on top of the slave cylinder
hope this helps
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the clutch bleed valve on a 1988 ford f-150?
On the clutch slave cylinder
How do you bleed a clutch on a Nissan stanza?
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
How do you bleed a hydraulic clutch system on a gmc sierra?
shhould be da same way u bleed your break system... bleed valve on clutch master cylinder...
Where do you bleed the clutch on a 1989 Honda Prelude?
You will find the bleeder valve on the Slave Cylinder, which is mounted on the front of the transmission, by the radiator. You will find it in the front and center of the engine compartment.
Where and how do you adjust the clutch on a 94 escort?
The clutch can't be adjusted. It is an hydraulic clutch. The clutch pedal sends pressure from the master cylinder to the slave cylinder on the clutch. IF you are having trouble with it the thing to do is bleed the air out at the slave cylinder. Have an assistant pump the clutch and hold it to the floor. Then open the bleed valve on the slave cylinder to let the air out of the system. On the final bleed hold the clutch to the floor and close the bleed valve on the slave cylinder. The clutch master cylinder operates of the brake fluid reservoir. Make sure you keep this full of brake fluid as you bleed the clutch.
Where is the cooling system bleed valve of the 1990 Honda Accord EX?
Bleed valve is located on top of thermostat housing.
How do you bleed the clutch. 2003 Mitsubishi lancer?
same way you bleed the brakes. push clutch all the way to the floor and release the bleed valve on the transmission. tighten it up, release the clutch. Need 2 people to do it.
Mazda b2500 clutch bleed?
Just bleed at the slave cylinder. It so easy, it takes 5 or 6 pumps but does need two people. One on the clutch pedal and one on the bleed valve. The person on the clutch pedal pumps a few time whilst you have the bleed valve open. Ask them to push the pedal to floor and hold. Close the bleed valve and then ask them to release their foot of the pedal. Open the valve and ask them to repeat the procedure again When pure fluid comes out make sure their foot is hard down and close off the bleed valve. Full clutch pressure will now be available. Cheers Jim from Oz
What does the clutch bleed valve look like on a 92 jeep wrangler?
On the opposite side of the trans from where the clutch line enters, a fitting with a bleed valve on the end. You can get a great view if you remove the access panel around the shifter, you will be able to see them both from there, loosen the end to bleed.
How do you bleed the master cylinder clutch on a 2000 Eclipse RS?
there is a bleeder valve on the right side of the tranny that is where you can bleed your system
Do you need to bleed the clutch after new install?
yes, u need to use the bleeder valve or u can gravity bleed it
How do you bleed a clutch on opel astra gtc?
Follow the clutch hydraulic line down to the bell housing. Note where the hydraulic line goes into the bell housing and if there is no bleed valve there you may need to remove a cover. Have a friend/assistant step on the clutch while you open the bleed valve. Close the valve and have the friend let up on the clutch. Do that a few times (making certain that the hydraulic fluid remains full) and you're done.
