Check the fuse
Bulbs? Sockets? Steering column switch?
whats the color circuit for the blinkers an break lights?
My rear window brake light works, but not my tail light brakes on my 1997 Monte Carlo. What is the problem?
Blinkers can work without brake lights. Brake lights are activated by a switch that is switched by the brake petal and the turn signals are acivated by your turn signal switch on your steering column. The two are two separate circuits. I suggest you check out the switch on your brake pedal to see if it is working properly. It must have 12 volts applied to one side when it is not acitvated and 12 volts should be on both sides when it is activated. When the 12 volts is on both sides of the brake switch, it should apply 12 volts to your brake lights and then they should come on.
Yes if the wire is part of the brake lamp switch
I have a 1983 GMC Sierra it has no dash,tail lights an brake lights are very dim
brake light switch is above the brake pedal under the dash
Well, that depends on whether you still have the lights and blinkers, ect. If there are not lights, blinkers, brake lights, or horn, then you do not need a battery to run this bike. If you do have these items, then you would need a battery
it may have nothing to do with your brake pads on my car the blinkers stoped working they still came on but they stoped blinking and i just had to repace the bulbs
my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri
might have a short in the wiring to the light socket!! same happen to me...
It is important to have working brake lights on a vehicle. If the brake lights are not working a person should first check the fuse, bulbs and at last the wiring.
the brake light driver side not working
The brake lights in your 1983 Nissan pickup truck are controlled by the brake light relay switch. When the brake light relay switch malfunctions the brake lights will stop working.
If none of the brake lights are working i would suspect the brake switch at the brake pedal.
You need new bulbs
I am currently having the same problem you are having check the fuse to see if it is blown the blinkers and brake lights are on the same fuse my system has a short in it somewhere and is popping the fuses I am in the process of running new wires since the wonderful people at Chevy ran all the wires thru the frame and you can't access them
it could be a plunger relay switch or pressure switch as some people call them. It will be mounted on the brake pedal arm. but i would check the bulbs first because if it is a dual filament bulb it could have gone out on one filament and not another. if your tail lights work and the blinkers work while the tail lights are on then most likely it is the switch on the pedal
The library has an automotive section with manuals that have all the schematics.
Check the brake light bulbs, Check the brake light fuse, Check the brake light switch, In that order.
It could be a couple of things. On some vehicles, if one of the bulbs burn out in the taillight or turn signal circuit, both will stop working, but only on that side of the car. Some cars also have the brake lights wired through the hazard flasher, which if malfunctioning, can cause problems for both circuits, on both sides of the car.
my lights are not working when i changed the pads on my peutgeo partner van
the connection between the battery and the brake lights
Change out the switch. Bad switch!!