Just what it is called. It Senses knock/Ping/Valve Clatter.Sometimes Caused by poor fuel / Bad Gas/Incorrect Timing. The sensor senses Noise/viberation then tells the computer to correct the timing retarde/advance. It is usally mounted on the lower part of the engine block right side. It looks like A temp.senser BUT larger with A single wire at the top.Good Luck Darwin B
location knock sensor 2002 pontiac grand prix gt 3.8 engine
The ECU is in the engine compartment on a 2002 Pontiac Grand Am. It is the sensor behind the converter.
Please answer the question. "How do you change an oxygen sensor in a 2002 Pontiac Bonneville
Screwed into the exhaust pipe
how to replace a knock sensor on a 2002 hyundai elantra
On a 2002 4.3, the knock sensor is located behind the driver side cylinder head. The knock sensor is very hard to reach.
You can test the 2002 Chrysler 300 M knock sensor with a diagnostic tester. The diagnostic tester will tell you if the knock sensor is working.
The knock sensor is located on top of the block in a 4.8 2002 engine. The intake will have to be removed to get to the sensor.
Why is 2002 pontiac grand am oil leak where the sparkplug is?
2003 chevy tahoe knock sensor
This knock sensor contains a phezioelectric material.
where is the location wiper motor Pontiac grand prix 2002
most likely you will have to replace the hub bearing assembly autozone for about $80
The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.
what causes the knock sensor code on a 2002 Kia Spectra. Thank You firstname.lastname@example.org
Trouble code P0128 means: ECT Sensor Below Thermostat Regulating Temperature
where is it located
where is the oxygen knock sensor located on a 3000 v6 Jaguar engine 2002 model and how can i change it?
The knock sensor on the 2002 Civic is on the engine block. It is located on the intake manifold just below the engine oil pressure switch.
The knock sensor are located in the valley between the cylinder heads on V6 and V8 engines V8s have two knock sensors
The 2002 Silverado 4.8 liter engine knock sensor is located on the back of the crankshaft. The back engine cover will need to be removed in order to view the sensor.
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
check out lugnutpatterns.com