The really early 283 didn't have a balancer.
It just had a flange to bolt the pulley to.
use a harmonic puller
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
Pull the retaining nut then use a puller to remove the harmonic balancer.
Yes.
The crankshaft position sensor is located behind the harmonic balancer. You will need a harmonic balancer puller and an impact wrench good for at least 750 ft pounds. Access the harmonic balancer through the passenger side wheel well. Remove the harmonic balancer center bolt and use the puller to remove the balancer. Use 1/4 - 28 X 3 inch bolts on the puller. The sensor is held with two screws. Be careful not to damage the weatherpack connector when releasing it from the sensor.
harmonic balancer has threaded holes for attaching the proper puller.remove big nut from shaft then use whell puller
Yes.
First remove the old one using a puller that you screw into the harmonic balancer there is a key on it so you can not put the new one on wrong just use the bolt that holds the main pully on to push the balancer on
Not too familiar with that engine, but never use a hammer to press it on. Go to your local Kragen, Shucks or autozone, they have a harmonic balancer installer in which you can rent. It simply screws into the center of the shaft and evenly presses the harmonic balancer onto the crankshaft.
Pull the belts, remove the center retaining bolt then use a harmonic balancer puller to remove the pulley. Make sure you use a disk that will protect the threads of the cranshaft when you tighten the puller.
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt