to make it insulated and rust free Gi spray is used.
Fiberglass is easy to install and can be purchased in insulation sleeves. The insulation is comprised of inorganic fibers, which are bonded with special resin. An aluminum-foil facing or vapor retarder is attached. The insulation is usually available in 3-foot sections.
condensate,bleed line of all condensate
Robert Stephenson Invented The Rocket (Steam line train)
No. If you refer to the Temperature/ specific entropy (T - s) diagram for steam, the line segment to the right of the critical point (the point of zero gradient) of the curve is called the dry saturated line and the left segment is the satuated vapour line. As self-explanatory as it sounds, dry saturated steam is on the dry saturated line depending on the given temperature or pressure. The quality (dryness fraction) on the dry saturated line is by definition 1, that means there is no portion of it as vapour. Hence it is in a fully gaseous state.
Stop Boiler Valve (or Crown Valve) is installed on an outlet line of a boiler. It's purpose is isolation of a boiler from a downstream steam line. Its position may be either open or close, it cannot be used for throttling of steam.
lard
Try insulating the fuel line with a NON-FLAMMABLE material as it passes by the engine up to the fuel pump. Especially protect the fuel line from the heat of the exaust manifold.
If I'm interpreting the question accurately, a "line isolator" is an insulating standoff for transmission or distribution cable. A bus isolator is an insulating standoff for tubular or bar bus as is normally seen in a substation switching yard.
The act of insulating, or the state of being insulated; detachment from other objects; isolation. 2. (Elec. & Thermotics) The act of separating a body from others by nonconductors, so as to prevent the transfer of electricity or of heat; also, the state of a body so separated.
Bluebell line
The leakage current in underground transmission line are any two conductors separated by an insulating medium. It constitutes a condenser and a capacitor.
for thrust balancing.
Due to pascals law
Triple point is a point on the phase diagram representing a particular pressure and temperature at which the solid, liquid, and vapour can co-exist in equilibrium.For water the values of pressure and temperature corresponding to Triple point are 4.58 mm of hg(610.42pa),273.16K.There are three lines drawn on the phase diagram.They are:1. Ice Line2. Steam Line3. Hoar Frost Line1. Ice Line: The line PB is called Ice Line.Along the line PB the solid and water are said to be equilibrium.2. Steam Line: The line PA is called Steam line.Along the line PA the water and steam are said to be equilibrium.3. Hoar Frost Line: The line PC is called Sublimation line (or) Hoar Frost Line.Along the line PC the Ice and Steam are in equilibrium.The Intersection of these three lines is Triple point.
condensate in the steam piping, probably due to improper slope of piping to allow condensate flow out.
NB means nominal bore
which material used in glassline reactors? What is glassline material ? Basic
A supply line filled with air, gas, steam, or liquid that's under pressure.