Best Answer


User Avatar

Wiki User

โˆ™ 2004-09-14 18:33:01
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: What is the best way to change the transmission oil and filter including oil in the converter on a 2000 Impala LS?
Write your answer...

Related Questions

How do you change the transmission pressure control solenoid on 2003 Chevy impala?

how do you replace a transmission pressure control solenoid in a 2003 chevrolet impala

How do you change a torque converter in 1979 ford f-150?

Pull the transmission and change it. The torque converter is inside the bell housing on the front of the transmission. Only way to get it out is to pull the transmission.

When to change Chevy Impala transmission fluid?

You should probably change a Chevy Impala transmission fluid every 3000 miles. This also applies to most vehicles on the road today. It is also important to check your transmission fluid at least twice a month.

What is the transmission fluid capacity for a 2002 Chevrolet Malibu?

Fluid and filter change: 7 qts From dry, including torque converter: 13 qts

When do i change my transmission fluid on my 2000 Chevy impala?

They recommend 30,000 miles.

How do you change the torque converter on a 1988 k1500 with a 350 engine?

Pull the transmission and change it.

How many quarts of transmission fluid 2003 neon?

The transmission holds 8.6 quarts total including the torque converter. A fluid change takes about 5 quarts. Use the dipstick to avoid over filling.

When do you change the transmission fluid in a 2004 Chevrolet Impala?

Every 30,000 miles would be best.

How do you change the front transmission seal on a 1991 Chevy Camaro?

You will have to remove the transmission and torque converter from the car to get to the front seal.

Where is the transmission filter on a 2001 impala?

Trany filters are inside the transmission pan. Usually changed when a trany service (oil change) is done.

How do you change the torque converter clutch on a 1998 Mercury Sable?

The torque converter clutch is inside of the toque converter. You must replace the whole torque converter as an assembly. The torque converter is sandwiched between the engine and transmission inside the transmission bellhousing. To access and replace the torque converter, the transmission will have to be removed. The trnsmission on that car is removed by raising the car on a hoist, supporting the engine with a special engine support tool, removing the lower engine cradle assmebly, and removing the transmission out through the bottom of the vehicle.

What causes whine when Chevy Impala changes gears?

A worn transmission gear can cause a Chevy Impala to whine when the gears change. A bad fan belt can also cause this.

How many quarts of transmission fluid does a 2006 Chevrolet Colorado hold?

from empty torque converter to full or from i drained tranny pan change filter and installed new gasket ?4 qts on filter replacement and about 10 on completely empty including torque converter.

Do you have to remove the transmission to change the torque converter on a 1999 acura tl?

You can either pull the trans or pull the engine. Your choice, But you must do 1 or the other to get to the converter.

How do you change the front pump on a turbo 350?

remove the transmission and torque converter. Remove the bolts from the pump (front of transmission case) and remove the pump.

How do you change the transmission fluid on a 1969 Chevrolet Impala?

The best thing to do is go to and locate a repair shop that has the BG chemicals. They will install a cleaner then back flush the system including the heater . Then they add a fluid conditioner.

When do you Change transmission fluid in a 2004 Chevrolet Impala?

For best performance it would be best to do so every 30,000 miles.

When do you change transmission in a 2004 Impala?

you change the tranny when it goes out if that's what you mean, other than that you should change the oil and filter in it between 30 and 50 thousand miles.

2005 F-350 automatic transmission fluid change amount?

19 qts full change/torque converter included.

How much transmission fluid does a 1997 Dodge Intrepid hold?

4.9 qts. ------------- For a fluid and filter change 9.9 qts. ------------- If Transmission and Torque Converter are dry.

How do you change front seal on 1997 dodge ram transmission?

you have to pull the whole transmission and remove torque converter and its right behind it.. very fun job......

Where is transmission filter located on 2003 Mitsubishi diamante?

Inside the transmission case. You'll have to disasemble the torque converter housing from the unit, so the transmission will have to be out of the car in order to change the filter . The most that you can do is change the fluid every 30,000 miles.

Should you change the torque converter with the transmission?

I would highly recomend you to replace the converter at the same time. I would also thoughly flush out the transmission oil cooler and lines. The transmission is an expensive investment and you don't wany ANY foreign material from the old, possibly blown transmission contaminating the new transmission. It would greatly reduce the life expectency.

How do you change a flywheel for a 1998 Ford Contour?

flywheel replacement generally requires removal of the Transmission and Torque Converter .

How do you change a torque converter on a 350 transmission?

take the tranny out and pull the converter out of the front of the tranny and put new converter in and make sure you hear it click twice when putting it back onto the tranny and reinstall tranny.