the tps is set by having a digital volt meter insert the probes in the top and middel connector on the tps then turn your ignition to the on position without starting the eng the volt meter should read 0.54 volts this is the perfect setting you can adjust by losing the two screws and rotaiting the tps to 0.54 volts then turn ign off and on again and check the volts . after removing the meeter start your eng , if that is your problem !!! hope this will help
water temperature in 85 corvette
On intake manifold.
Gm does not use inertia switches.
hydraulic lifter non roller
Head lights
== ==
According to my Alldata system maintenance charts, the 85 Corvette OD manual trans uses Dexron IIE automatic trans fluid. HTH
If the 85 is a similar bodystyle to the 86, yes.
on my 85 its behind the plastic thing on the top of the place were your feet go
.045
shift linkage needs adjustment, not expensive
depends on what sensor - hi pressure, low pressure? Which one are you looking for?