0
it shows some reading even though battery is low because of there will some flux remains in the magnets
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What happens when a bulb ammeter battery and switch are put connected together?
the bulb will glow and ammeter will show the reading
How do you use an ammeter?
The Positive side of the Ammeter should be connected to the positive side of the battery and the Negative side should be connected to the Globe/Conductor/Insulator to provide a valid reading.
What is voltage reading on circuit with 6 volt battery 1 ammeter 1 50 ohm resistor?
i=v/r can be used to it
A 9 V battery is hooked in series with two resistors R1 75 and R2 100?
You'll get a reading on the ammeter showing 15 mA
What will happen to the ammeter reading if the resistance is increased?
The current decreases due to I=V/R. The ammeter reading will decrease as R is increased.
How do you wire in the ammeter on a battery charger?
In series
What would happen if a voltmeter were substituted for an ammeter?
Smoke. Since a voltmeter is in parallel with the load it is right across the source voltage. Putting the amp meter across the line with its low resistance it will act like a fuse, hence the smoke. Newer solid state testers are usually smarter that the operators. They have built in circuitry which sense the wrong settings you are using and shut the tester off with a "beep" to let you know that you are doing something wrong.
How is the reading on an ammeter be affected when one of the parallel resistors is removed?
decrease to half of its original value
What device shows the amount of energy a battery is producing?
That would have to be a 'wattmeter', but they're seldom available. In terms of more readily available instruments, you'd need to use a voltmeter, reading the battery's voltage, and an ammeter inserted in series in one of the battery's connections, reading the current from the battery. The rate at which the battery is supplying energy at any moment is then the product of the two meter readings.
Battery connected to high Resistance voltmeter the reading is 1.5V when it is shorted on a low resistance ammeter the current is 2.5A what is the emf and the internal resistance of the battery?
The Thevenin equivalent circuit of this battery is 1.5V and 0.6 ohms in series. A more exact answer cannot be given without knowing the actual resistance of the 2 meters (I assumed infinite for the voltmeter and zero for the ammeter, as would be for ideal meters).However I would NEVER attempt this test as you describe it, many types of batteries will explode like bombs when shorted (as they would be when an ammeter was placed across them)! The correct way to do this test safely is with just a voltmeter and an adjustable high wattage resistor.
When an ammeter is connected in a circuit which terminal of the battery must be connected to the positive terminal of the ammeter?
The positive terminal of the battery would be connected to the positive terminal of the ammeter. The load would then be connected between the two negative terminals, positive side of the load being connected to the negative side of the ammeter.
Will a fully charged new battery have a low conductance reading?
No it will have high conductance
